Your cart is empty.
Your cart is empty. Features
Low ON-State Resistance (10 Ω)
Low Charge Injection
Excellent ON-State Resistance Matching
ON-state resistance (ron): 7 Ohm
ON-state resistance match (ron): 0.3Ohm
ON-state resistance flatness (ron(flat)): 5Ohm
Low Total Harmonic Distortion (THD)
2.3-V to 3.6-V Single-Supply Operation
Control Inputs are 5-V Tolerant
Latch-Up Performance Exceeds 100 mA Per JESD 78, Class II
Turn-on/turn-off time (tON/tOFF) :3.5 ns/2 ns
Charge injection (QC): 2 pC
Bandwidth (BW): 300 MHz
OFF isolation (OISO): -48 dB at 10 MHz
Crosstalk (XTALK): -48 dB at 10 MHz
Total harmonic distortion (THD): 0.2%
Leakage current (ICOM(OFF)): +/-5 μA
Power-supply current (I+) : 2.5 μA
Applications
Sample-and-Hold Circuit
Battery-Powered Equipment
Audio and Video Signal Routing
Communication Circuits
Package Inclucded:
1pcs NOYITO TS3A5018 10Ω Quad Channel SPDT Analog Switch Module
Bob Winger
Reviewed in the United States on April 11, 2024
I installed this in a generic breadboard with a power supply module that had no instructions. I initially turned on the power supply and the module didn't work. Then I noticed the module was getting HOT! Rechecked wiring a couple times and it was still getting hot, so I didn't miss-wire anything? Then I thought maybe the power supply was providing 5 volts instead of 3.3 volts. Hooked up my DVM and found the voltage polarity was reversed!! Turned the power supply module around and 3.3 volts supplied with correct polarity.I'm impressed. This thing still works after screwing up the power supply polarity. Forehead slap.
Recommended Products
