Your cart is empty.
Your cart is empty.OTC's Bearing Splitters feature 'knife-like' edges which are easily placed behind the part to secure a gripping surface, even when clearances are extremely limited. When used with an OTC 'Grip-O-Matic' puller, puller jaws grip attachment’s outer edge. When used with a Push-Puller, puller legs are threaded into the attachment’s two tapped holes. Constructed from high strength materials designed for long term use under the harshest conditions. Min. spread - 1/2 inch, max. spread - 9 inches. Distance between threaded inserts - 6 inches. Tapped holes in face of splitter halves - 5/8-18. Use with puller nos. 1035, 1040, 1041, 1042, 1065,1063, and 938. Value is at the core of the OTC tool and equipment portfolio. Whether it’s a simple repair or the most complex drivability concern, these award-winning tools universally solve problems faster, and at better value, than any other product line available. Whether it’s a specialty tool or unique piece of service equipment, OTC provides top solutions to modern automotive service challenges while increasing technicians’ productivity and shop profits.
R. Redd
Reviewed in the United States on January 25, 2025
This is the second OTC bearing splitter that I’ve purchased. I have one that I’ve been using for well over 30 years with no issues. Theses are great bearing pullers. You will not be disappointed.
Randy T
Reviewed in the United States on December 31, 2024
If the bearing fits in the range of this puller its coming off. No ifs ands or buts.
Oleg
Reviewed in Canada on December 13, 2023
It was missing two nuts. I had to buy separately.
Mike
Reviewed in the United States on July 14, 2022
Not possible to use on a 9” bearing do to the distance between the shafts
Kollin Kennedy
Reviewed in Canada on February 12, 2021
I wish there was replacement tie bolts. Had to buy a whole new one to get.We use it to pull 200 - 350 hp drive couplings with interference fit.
Brian Blackburn
Reviewed in Canada on November 26, 2021
Worked like a dream!
James G
Reviewed in the United States on November 14, 2021
A bit pricey for the tool but very versatile.
Richard Zell
Reviewed in the United States on December 22, 2020
Exactly the tool I needed and wanted. Works great
Jamie
Reviewed in Canada on October 20, 2019
Great quality. Fast delivery.
David b
Reviewed in the United States on April 6, 2019
You want to press stuff?!?! This is it. Primarily use it for 4 runner front hubs but so many other things. Perfect tool.
Customer
Reviewed in Canada on June 7, 2018
ok
va-sawyer
Reviewed in the United States on November 25, 2012
I use this splitter mostly for pressing off pinion bearings. It does a very good job of fitting in by the shims, and holds up to the pressure of pressing out the pinion without distortion. Made from high quality steel, the thin edges haven't shown any signs of bending. It has exceeded my expections, something that very seldom happens anymore when it comes to tools.
Ponydrvr72
Reviewed in the United States on April 1, 2011
This tool came with alot of the casting material still present. If you were to use it strait out of the box the bolts would warp because of it. I spent a good hour with a heavy file to remove the casting so the nuts would rest flush on the splitter. while removing a pinion bearing on a 9" the inner eye area became distorted while removing the bearing on the press. The tool say's right on it," Made from global outsourced materials" That might mean China.But for the money this tool is hard to beat if you plan on only using it on a few occasions,but if you are a proffesional, look else where.
Recommended Products
