Your cart is empty.
Your cart is empty.OTC 1 inch and 1-1/16 inch Oil Pressure Sending Unit Socket is designed to easily remove an oxygen sensor. It is a heat-treated cast steel., 1-1/16 inch and 1 inch oil pressure sending unit socket.
Nublet
Reviewed in the United States on June 21, 2020
Fit a Silverado just fine. Had it on and off for testing in less than 20.
Cody Baker
Reviewed in the United States on July 22, 2018
Awesome to have has definitely paid for it’s self
Nichi
Reviewed in the United States on February 25, 2018
Quality is great compared to other brand. However, this tool is not 2.3" long as stated in the description. It's nearly 3" long. Please fix the description of this product.
Robert Moy
Reviewed in the United States on February 19, 2018
Didn't know which size my sender required so I order this socket, it turned out that my sender required a 1-1/16. Work great in removing the oil pressure sensor for a 2005 Camry with the 2.4L Removing the connector wire was the hardest part. Press on the tab and pull the connector off.
Lala
Reviewed in Canada on May 20, 2017
Looks good
Ralph
Reviewed in the United States on November 15, 2017
Needed this for work and it was much less expensive than the tool trucks.
robert bacorn
Reviewed in the United States on December 2, 2016
Not deep enough for a gm oil pressure sender
Punkin
Reviewed in the United States on April 29, 2015
Great Idea, however it was not deep enough for my 1998 5.2 dodge ram. Had to get a Lisle to fit the Dodge Oil pressure sensor
LeroyPTLC
Reviewed in the United States on August 29, 2012
I knew that I was only going to get the one socket, but the picture does show otherwise. The socket you get is the one all the way to the right side of the screen. I lost mine and needed a replacement. If you read the description you know what you're getting, but if you just look at the picture you will think you're getting an awesome deal and be very pissed off when only one socket shows up.
Recommended Products
$26.29
$ 12 .99 $12.99