Your cart is empty.
Your cart is empty.OTC 2-1/4 inch Wheel Bearing Locknut Sockets easily remove or install locknuts. These are specially designed sockets. They're made of high strength steel and resist rounding out. These Sockets are designed for use with 1/2 inch square-drive manual tools only. Measure from flat to flat to determine size of locknut. The use of impact tool will void the sockets..
Jeff Amos
Reviewed in the United States on July 22, 2021
Works on a 2000 nissan frontier 6cyl.
Lance Campbell
Reviewed in Canada on November 5, 2021
It didn’t fix the 2001 Pathfinder like it says.
Calogero A.
Reviewed in Canada on June 15, 2020
I use this for my 2003 nissan pathfinder R50 4x4 and i works great makes the job a lot easier and safe. Make shure to have a good hold on it.
Brent
Reviewed in Canada on August 1, 2019
Took like 3 months to recieve it. But once I got it, it worked as described. Hard tool to find. I used it for my 2003 Nissan xterra
Garfield Hamilton
Reviewed in the United States on May 16, 2018
It worked great. I had no problems with this socket. I used it to properly seat the wheel bearings on my pathfinder according to specifications.
Tyler
Reviewed in the United States on September 14, 2016
It didn't last ten minutes. I blew a bearing in my 2wd 2001 xterra and this fit the locknut holding the hub on there, but the prongs literally broke off after the first couple tries at forcing the locknut off.
Richard G.
Reviewed in the United States on December 29, 2016
As a mechanic, OTC is always a safe bet for a quality tool. I needed this for a Nissan 4x4 pickup, worked perfect.
Cliff Barnhouse
Reviewed in the United States on November 26, 2016
I got this so I could adjust the wheel bearings on my daughter's 2000 Rodeo. It fit the hub nut perfectly and allowed me to properly set the wheel bearing torque. My Dad taught me years ago a job is easier when you have the proper tools.
Hong Chea
Reviewed in Canada on August 1, 2014
Worked great on a 2003 nissan pathfinder bearing retainer
Jake E Walgenbach
Reviewed in the United States on December 16, 2014
On the package it doesn't say that it will work with 2000-2004 xterra and frontier 4wd models, but it will. I thought it wouldnt at first because the knobs were too big, so i ground them down. Then I realized that I hadn't removed the lockwasher, and that the knobs would have fit.Either way, anyone wonder if this will fit on 1st gen frontier and xterra 4wd front hubs, IT WILL
FRONTIER MAN
Reviewed in the United States on July 21, 2012
I BOUGHT THIS SOCKET FOR MY 04 FRONTIER AND SAVED MY SELF ABOUT 700 DOLLARS! THIS WAS VERY EASY TO USE AND WOULD TELL ANYONE WHO IS GOOD WITH A WRENCH AND WANTED TO SAVE SOME MONEY TO GET ONE.
Peter
Reviewed in the United States on July 13, 2012
Great tool for my 1997 Nissan Pathfinder R50. If you have this care, you have to have this tool to remove the brake rotors and also to torque the wheel bearings correctly. Worked like a charm.
Recommended Products
