Your cart is empty.
Your cart is empty.These low silhouette versions of the muffler / filter are useful where space is a problem and / or to . Use for vacuum relief or pressure equalization in gear boxes, oil tanks, reservoirs, etc. Non-corrosive. The silencer is designed to give superior performance in noise control with a minimum effect on air efficiency. "Trimline" design allows location in the tightest places without extra plumbing and fittings. Fits directly into the exhaust port of more than 90 percent of present commercial valves. Slotted body permits rapid discharge of air without undesirable back pressure. Unique nylon screen element resists dirt buildup or clogging. Ambient temperatures below freezing require moisture-free air. Ambient temperatures below freezing and above 180 degree require lubricants especially selected for suitability at these temperatures. Pneumatic valves should be used with filtered and lubricated air. 893 Flow SCFM at 100 PSIG Inlet, 1.62" Hex.
mommyo
Reviewed in the United States on January 21, 2020
Works
Lee
Reviewed in the United States on July 2, 2019
Used it on an 8hp Briggs Stratton thought it would help the noise. It did not help the noise exhaust also the exhaust comes out the sides not the end which the heat was not projected out. Had to used old muffler. Would not recommend. Wasted the money.
Barry H. Thomas Sr.
Reviewed in the United States on September 16, 2015
Significantly reduced the exhaust noise from a bulk storage distribution pump.
Recommended Products
$112.67
$ 55 .99 $55.99