Your cart is empty.
Your cart is empty.Simplify inserting your glued up pen tubes into your blanks; Keeps your fingers clean and safe from residual glue. Tapered, chrome plated, glue resistant tool compatible with tubes from 7mm to 15mm in diameter; #2 Morse Taper end so that you can either mount on your lathe, or grip with your hand. Mount it into your lathe's #2 Morse Taper headstock, slide on the pen tube, then turn on the lathe to quickly and conveniently sand, glue, or paint the tube; Use it on or off the lathe to insert your glued up brass tube into your drilled pen blank. For gluing, place your pen tube over the end of the tool; Cover the entire surface of the tube with the glue of your choice; Slide the tube inside your pen blank with a twisting motion while still on the tool; Slowly release the tool from inside the blank, making sure the tube is centered; Allow your work to dry and cure properly. More Tube Insertion Tools are available without the #2MT end: PKTINT is compatible with tubes 7mm to 11mm diameter; PKTINT2 is compatible with tubes 7mm to 15mm diameter
$11.95
$ 5 .99 $5.99