APO
Reviewed in the United States on March 8, 2025
Replacement cap for Delta drill press, floor model 17-900
J Walk
Reviewed in the United States on January 27, 2025
Simple and exactly what I needed. They fit as expected.
Michele
Reviewed in the United States on January 24, 2025
These are way smaller than the 3/4 inch I ordered. I am so disappointed. I will have to send them back.
B. Mass
Reviewed in the United States on September 11, 2024
was needing to replace a cap on a running board, looked everywhere, nobody had replacement parts, said i would need to by a new set of running boards, I only needed one. found these worked great, perfect fit, can't tell they have been replaced.
Michael Anderson
Reviewed in the United States on June 25, 2024
When the package came I didn’t think these would fit my Roland electronic drum stand even though they’re the stated width. I hammered them in using a dish towel over them to keep them from shattering and they fit perfectly, for about 1/10th of what actual Roland caps would cost.
Regretz99
Reviewed in Canada on February 25, 2024
Fast delivery and cheap , also fit perfect on the ends of my running boards
David from Missouri
Reviewed in the United States on April 18, 2024
I needed some ends , for some card boad tubes bought these they are under sized but will work with some tape
Eric Bohlmann
Reviewed in the United States on February 22, 2023
These worked great to replace a missing plug on a smittybuilt tube bumper.
Kat
Reviewed in the United States on December 8, 2023
Ok so these caps are just a tad smaller, or maybe they just have a smaller diameter ribs on them. In any case when I'm installing these on 1.5 inch sofa legs, they kinda cave in. If they were truly 1.5 inches they would fit perfectly. Maybe these are in mm size which is a bit smaller, but this little defect makes them very unreliable and frankly even unusable.