Shopping Cart

Your cart is empty.

Your cart is empty.

Rancho RS8131 Leaf Spring Alignment Clamp Kit

5.0 (10) Write Review
Free shipping on orders over $29.99

$16.31

$ 7 .99 $7.99

In Stock

About this item

  • COMPATIBILITY – Universal fit, check product dimensions
  • GET THE RIGHT PART -- Before purchasing, research to ensure that the part will fit your vehicle; enter all vehicle information (year, make, model, engine and trim) for compatibility and check qualifier notes
  • COMPATIBILITY -- Universal fit to work with most aftermarket lift kits
  • MAINTAINS SUSPENSION ALIGNMENT -- 2.5-In. wide leaf alignment clamp kit keeps spring pack aligned for proper suspension
  • FOR LEAF ADDITIONS -- Use when adding a leaf to a factory spring pack
  • ENGINEERED TO LAST -- Made of carbon steel for long service life
  • HARDWARE INCLUDED -- Kit includes everything you need for one side - two U-clips and cap (purchase an additional kit if you're doing both sides)
  • BUY WITH CONFIDENCE -- Comes with Rancho's limited one-year warranty


Designed to keep your spring pack fully aligned, install the Rancho® 2.5-in. leaf spring clip when adding a leaf to a factory spring pack. The kit includes everything you need for one side.


D Brooks
Reviewed in the United States on September 29, 2023
88 F150 4.9-fit
Murcon
Reviewed in Canada on September 11, 2023
I ordered two and both parts came in opened bags with 1/2 missing ... not impressed
Karissa Stryker
Reviewed in the United States on May 27, 2023
These worked great on my broken 1991 Dodge w150 rear leaf springs.
Bob
Reviewed in Canada on October 27, 2023
Exact fit. In time. Good quality.
Tagg33
Reviewed in the United States on June 14, 2021
I added a leaf to my Jeep XJ spring pack and this clamp kit worked perfect afterwards. Nice thick metal. I reused the rubber pads from my stock clamps on these and it turned out great. Saw another review where someone said they wished clamps came with rubber part.
Ken Johnson
Reviewed in the United States on April 29, 2021
The material is thick and strong. Its hard to get the recommended loop bend in the holding bracket. When installed properly, they do the job well.
Joe
Reviewed in the United States on February 23, 2020
nice thick steel with great coating that did not flake off when bent after install. also fit perfect on my 2 1/2 wide springs. instructions were simple and correct.
Frank Bullitt
Reviewed in the United States on December 19, 2020
They fit my 1964 Chevy ll 2 inch wide mono leaf springs perfectly. They are soft enough to bend with a hammer or channel locks. Basic instructions in package.Not as heavy as the clips that come with new vehicles but they work. If you take them off after you put them on it is harder to put the same ones back on.
Stanward S. M. Oshiro
Reviewed in the United States on November 4, 2020
Very heavy duty. The metal is much thicker than the Pro Comp brand. Very easy to install. Came with instructions. They recommend to roll the ears over and make a loop, am unsure on how to do this. I used large groove joint pliers and a C clamp. Bent the ears enough and used a hammer to pound it flush.
Jak4
Reviewed in the United States on February 20, 2014
I was expecting it to be a bit bigger. It only grabbed hold of 3 leaf springs same as my stock clips (2000 tundra). I wanted at least 5 to fit, but it's helped to reduce squeaking and the build quality is what you'd expect from an off road supplier, all in all I'd buy a longer set if I had to do it again, but rancho is good quality.