Juan Antonio Chavez
Reviewed in Mexico on January 22, 2025
Esta muy bien y trae sus valeros dentro si lll pides para la moto que es 👍
Joel Magadan
Reviewed in the United States on September 5, 2023
Great replacement for my 2009 trx400
Christine
Reviewed in the United States on October 14, 2022
Beautiful machine work. It arrived in a box in a box. No box damage at all. They packed it with this damage. This is supposed to be machined to fit perfect and tight. Hope it works don't have time to wait for a return. The only pro lem I have is they packed it in the box with this damage.Finally installing today, will not fit properly, no O rings. Not when a place for an O ring. Sadly we can not return so now out the money. DO NOT PURCHASE THIS JUNK.
Duane Davis
Reviewed in the United States on July 8, 2021
This one is greasable and I recommend it for all TRX application.
Michael Sandifer
Reviewed in the United States on June 18, 2021
I was a bit worried with how cheap it is but so far its working just fine. It seems true that you need to push the bearings in farther but thats easy to do. I’ll be back at the end of summer to update this review to let everyone know how it holds up
kenneth kandarczyk
Reviewed in the United States on May 1, 2020
Liked the aluminium construction..very nice bearing assy. But however the bearings were not pressed all the way back into the carrier. Had to do a little modifying. Overall it worked out very nice. I gave it a 4.
Ryan Gray
Reviewed in the United States on September 1, 2019
Carrier looked exactly like the one I pulled out of the machine. Its well built, and I like the zirk fitting to grease it. HOWEVER, the bearings had to be pressed in further in order for the rotor hub to seat in all the way. Even after pressing the bearings in as far as they would go, this still didn't give me enough room to get the c clip on, on the rotor side. I will be sending it back and requesting a full refund. It is a very close fit, but I was unable to use it.
Delaney McGonigle
Reviewed in the United States on August 22, 2019
It fits well in the swing arm of the 400ex but they did not send a new c clip (old one is to big) also had to get a bushing machined for the rear caliper bracket (way to much play between bracket and carrier)
Todd_
Reviewed in the United States on November 11, 2018
Really nice product. The fit was perfect and installation was relatively straight forward. Can’t beat the price as well! Took my TRX400EX out for a ride after I was done and it was like a new machine again.