Your cart is empty.
Your cart is empty.2302-MSS Rear Window Defroster / Defogger Replacement Tab. Compatible with Jeep use only. Replace the damaged or broken metal rear window defroster tabs located along the sides of defrosters and defoggers. A visual match with the undamaged tab is the most reliable way to ensure you get the right tab. Use the Frost Fighter 2000 Defroster Tab Bonding Repair Kit to re-attach tab to the defroster. Frost Fighter is a Registered Trademark.
Forrest
Reviewed in the United States on March 13, 2025
Worked for me cheaper than new glass
FT
Reviewed in the United States on September 12, 2024
Worked perfectly on a Jeep JK.
Scott Olsen
Reviewed in the United States on July 23, 2024
Superb replacement for the rear window tab on my Jeep Wrangler
Kurt
Reviewed in Canada on November 27, 2024
Works for my 2016 jeep wrangler defroster
GSC
Reviewed in the United States on April 7, 2024
I removed the back glass to make it easier to do the fiddly part. I did not sand the connection point down. I added a little solder to the button and heated it with a soldering iron until it settled down the window. So far so good.
esteban
Reviewed in the United States on April 27, 2024
When your defroster tabs loose the glass connectionThis product gives you the tabs, buy the silver epoxyAnd follow the instructionsHeat cure the fixed tabsI was told I need a new rear window in my jeepIn 30 min my jeep was better than newThis is a great productLittle pricyBut that pesky electronic tab is fixed and back on the glass, like it was welded.I tried many YouTube fixesThis one works without a mess. Well worth the money for the tab and adhesive kit
avayatech
Reviewed in the United States on June 4, 2023
Excellent Part - Just what I needed to fix broken rear defroster tab on 2016 Jeep Wrangler!!!Dealer wanted over $1000 to replace rear glass to fix broken tab - $20 later fixed - will see if holds, but after couple days, still in place and working.
Jon
Reviewed in the United States on December 8, 2023
If you have the ability, solder it on. Seems like the epoxy is hit or miss. Best to remove the glass and solder it inside for better adhesion. But it's possible to do it upside down.
jaimi
Reviewed in the United States on March 16, 2021
The foot print of this "tab" is too small and builds up enough localized heat that it melts itself free from the surface.My fix was to hard solder this tab to a 1.5 in flat round of copper, which has 5 x as much surface area, and adhere that to the defrost area. This did the trick and has not failed yet.
Recommended Products
