Your cart is empty.
Your cart is empty.American-made RV hard bumper plugs. These plugs are made using a dense high-impact rubber material that will not fade or shrink - perfect for a life on the road. Tough enough to stand up to harsh weather and road conditions, variable temperatures, and constant exposure to sunlight. 3.75” square design and tabs ensure a snug and secure fit. Center hole offers air ventilation and makes removal of plugs easy. Should not be cleaned with ammonia or harsh cleaning agents. Fits 3 ¾” bumpers.
HUH???
Reviewed in the United States on July 22, 2021
Great product. I lost a cap and my poop hose slid out. Very embarrassing! I lead a swinging lifestyle and have the to worry about appearances. Having a poop hose dragging is very disconcerting. This solved my problem. Great product!
Steve C
Reviewed in the United States on June 11, 2021
Not sure if it was just a wrong item sent or if the ad is misleading, either way it states end caps with tabs and there were none. I returned item and ordered from a different supplier which was a little more expensive but worth it.
lh
Reviewed in the United States on May 3, 2020
I fit perfectly inside my 4" camper bumper. I had ordered a cheaper one from another company that was exactly 4" and it would not fit inside the bumper. This one is slightly smaller than 4 inches and has small tabs on the side that will fit inside the notch in the bumper. Great fit. Worth the higher price.
Stan Evans
Reviewed in the United States on November 8, 2020
Nice looking and construction appears durable
Mark Kostreba
Reviewed in the United States on November 10, 2020
They work great!
Profedeseattle
Reviewed in the United States on November 3, 2017
Dimensions listed are incorrect. My bumper opening (inside dimension) is just a bit over 4" square (4 1/16"). These would fit fine in a 3 3/4" bumper, as they are just a hair under 3 3/4" measured across the part that fits in the bumper. As is, they just fall out when I try to insert them. They should be specified as "Rubber Bumper Plug End Cap Cover for 3 3/4" ID bumper".
william F. Reynolds
Reviewed in the United States on August 24, 2016
Fit tightly, can't beat the price.
Isabel Goyer
Reviewed in the United States on October 14, 2016
Well made but a lot more rigid than I expected. If your square channel bumper is a little out of square, as they tend to get, these are not very forgiving of that. I had to use a hammer to get them to fit better, and even so, I'm nervous they're going to fall out, so I'll pack something inside of them for a while to keep my drain hose secure in case they do decide to depart the premises en route somewhere.
Recommended Products
