Your cart is empty.
Your cart is empty. Meet or Exceed OEM Specification
A Clip Which Helps Secure The Curtain Air Bag Inflator Module To Its Mounting Point. A Clip Which Helps Secure The Decklid Latch To It's Mounting Point. A Clip Which Helps Secure The Roof Header Panel To It's Mounting Point. A Securing Fastener Which Helps Hold The Roof Bow In Place. A/c Condenser Clip . Bolt To Secure The Roof Header Panel. Clip That Fastens Radiator Support Or Radiator Baffle. Club Cab. Cowl Cover Clip . Cowl Insulator Clip . Cowl Top Panel,rivet. Engine Air Intake Hose Clip . Fastens Fender Liner To Vehicle. Fender Flare Clip . Hardware Used To Attach Bumper Cover To The Vehicle. Instrument Panel Air Duct Clip . Instrument Panel Trim Panel Clip . Lower Insulator,fastener. Molding,pin. Mud Guard Clip . Package Tray Trim Clip . Partition Panel Clip . Quad Cab. Quarter Panel Splash Shield Clip . Quarter Panel Trim Panel Clip . Radiator Air Seal Clip . Radiator Support Air Deflector Bolt . Radiator Support Air Deflector Clip . Rear Body Panel Trim Panel Clip . Rear Floor Duct. Regular Cab. Retaining Ring Used To Secure The Cv Joint. Rocker Panel Molding Clip
STOSH
Reviewed in the United States on February 4, 2025
Received as advertised. Used in another application that this is not intended for and it worked just awesome. Added R-8 HVAC duct wrap insulation to existing hard fiberglass board on the exterior. Pushed the pins thru the wrap into the duct board, worked great!
Furious Screed
Reviewed in the United States on February 14, 2025
I bought them for a car I ended up junking and then misplaced them, but I'm sure they would have been great.
Sarah
Reviewed in the United States on September 24, 2024
Got these for my son’s 99 dodge 1500. Works perfect
Morgan V
Reviewed in the United States on August 3, 2024
Got these for my 2016 Ram 1500 Sport. Good quality. The same if not better than the factory ones.
Bob Pennell
Reviewed in the United States on February 16, 2024
I found that these clips were too small for my 13 Dodge Challenger. I was using them on the wheelwells and they definitely are too small for what I need. They need to be just a little bit bigger for your information. Hope this helps.
C. R.
Reviewed in the United States on December 1, 2024
We got the Rexka 100pcs Fender Bumper Shield Fender Liner Push Pin Retainer Clips to use in a DIY van build to hold up side panels.The clips were easy to use and we received the right amount. They were the right length and they stay in the holes after inserting.If we were to do a van conversion again, we would buy them again.
KevinD 2500
Reviewed in the United States on November 26, 2024
I used this product for the inner fender on my 2004 Jeep TJ. The fit was perfect.
Regina
Reviewed in the United States on November 1, 2019
The plastic that is in the top of my tail gate was held on by one plastic "domaflatchi" and these fit great... I also used then to secure the plastic panels I removed for my B&W ball hitch install as well. Worth every penny and you have soared for later.
Recommended Products
