Your cart is empty.
Your cart is empty.Pen Name
Reviewed in the United States on February 19, 2025
Works well. Accurate for measurement. Great bushings.
Lightning546
Reviewed in the United States on February 24, 2018
Once I read the instructions the bushings were very easy to setup and center on my router base (Dewalt DW618), the only problem with these bushings is, they are 1/16" too long (the section that goes into the dovetail jig). This means that whenever I need to make a dovetail joint that I have to either lift it over the wood clamped in my dovetail jig or use a shim between the top of the wood and the bottom of the top plate of the jig. Then I can make the cut, which results in my having to finish the cutting process with a saw and chisel. I also have to re seat the 2nd piece of wood in the jig so that the joints are cut deeply enough to match the other side of the joint.Other than that it's a very nice set of brass bushings.
Photog Dad
Reviewed in the United States on January 22, 2018
worked very well. I am a novice and really needed these to complete a DIY crib
Denise
Reviewed in the United States on January 13, 2015
Very nice! Works great. Very strong, case is nice too!
Andy
Reviewed in the United States on January 11, 2015
I own another set of guide bushings (needed two bushings of the same size). The Rockler set is far better quality, and I like the self-centering cones they provide too. For the price, these are very good.
MS Diego
Reviewed in the United States on September 7, 2014
Works great. Watch the guide bushing depth since they are not all the same. Make your guide or template the correct thickness to extend past the bushing.
J. Fergus
Reviewed in the United States on January 19, 2013
As with many Rockler products this kit is well made and designed. The case provides easy storage so that the guides are easily found and stored. They are made of brass and I have found them machined well.A woodworker's must have.
M L
Reviewed in the United States on September 27, 2010
The first time I used the insert it got loose in the router and the bit slightly rimmed the side of the bushing. I had to tighten the guide bushing with a pair of pliers. That took care of the problem although I am not at all sure that the use of the pliers were intended. Otherwise, I think it is great.
Recommended Products
