Your cart is empty.
Your cart is empty.' Rod Stock, 150, Acetal Homopolymer, White Color, Diameter 1/4 In, Length 1 Ft, Diameter Tolerance +0.003/-0.000 In, Length Tolerance +0.125/-0.000 In, Min Temp Rating 32 Deg F, Max Temp 180 F, Tensile Strength 11, 000 PSI '
lil'john
Reviewed in the United States on February 24, 2021
Used dremel cutoff wheel, took sharp edges off, installed, and have QUIET FIERING NOW!1.250 long so I now have enought to make spares!
Jr.
Reviewed in the United States on October 8, 2021
I bought it to make buffers for my 10/22 rifles...works great for that, better and cheaper than using the nylon bolts that so many are using, it's a little oversized to the original steel buffer but can easily be put in a drill chuck and turned down to fit better or just bevel the end a little and tap it in the hole...either way will work !!
Paul S.
Reviewed in the United States on December 17, 2020
Perfect fit for my Ruger 10-22 buffer pin! No cutting off nylon bolts etc.
Willie
Reviewed in the United States on January 4, 2019
training your kittens to be in a circus... (cats loved this rod/wand)this rod is an excellent provider of a Ruger 10/22 bolt buffers when cut to 1.25" lengths... the diameter is slightly larger than the slip-fit steel used by factory receivers (0.26 vs 0.25), but if the rim edges are slightly chamfered, the new buffer is easily tapped in using a nylon hammer (to avoid marring the receiver) - you'll save money over commercial buffers!the rod *appears* to be a Delrin or generic 150 acetal, and as such should have the following mechanical properties:MechanicalTensile Strength (PSI) D638 11,000Tensile Modulus (PSI) D638 450,000Tensile Elongation at Break (%) D638 30Flexural Strength (PSI) D790 13,000Flexural Modulus (PSI) D790 450,000Compressive Strength (PSI) D695 16,000Compressive Modulus (PSI) D695 450,000Izod Impact (Notched), ft-lb/in D256 1Rockwell Hardness D785 M89, R122i'm taking off a star due to no link to a specific data sheet
Recommended Products
$26.99
$ 13 .99 $13.99