Your cart is empty.
Your cart is empty.FRANK
Reviewed in the United States on February 26, 2025
Fits 1 1/4" stem and bars perfectly. Price is a little on higher side but it is reflected in the quality and finishing. It would be even better if we could order custom riser heights
Aaron
Reviewed in the United States on July 31, 2024
Bought these for my 2021 Harley-Davidson Pan America (RA1250S) and they work.
TaylorVersace
Reviewed in the United States on March 1, 2024
Just what I needed. Angled it to add 1” rise and 1.5” pull back. Not difficult to install. You have to be clever installing it if your angle of installation blocks your way from tightening the bolts…. but doable.Quality built and looks good.
Serge
Reviewed in the United States on November 5, 2024
these could not have fit any better on the new lyric graffiti x e-bike that comes with 31.8mm handlebarsonly thing is try to find a small hex wrench that fits in the groove
Jim Goodman
Reviewed in the United States on November 20, 2024
Just what I needed. Worked perfectly. Received sooner than expected.
artisannm
Reviewed in the United States on August 21, 2023
I have the Kawasaki Vulcan Vaquero and have a limited choices for extending my handlebars which they mount way down inside the triple tree? No idea why. After installing a set of straight risers that lifted the bars about 2" my short arms wouldn't let me sit back properly in the seat, so I found this item on Amazon, and it mounts inside the original space where the handlebars go.Then you just rotate these extenders so you can get another couple of inches pullback and add the handlebars into place on these ones.Before I was leaning forward and holding the grips by my fingers. Afterwards, I can sit back, and the grips are now in the palms of my hands. FYI - I'm 5'5.Overall, it's a bit of a 'jerry rigging' affect, mounts inside mounts then connecting the bars, but it worked. I did have to remove the master cylinder brake line and reroute it then securing it again to the master cylinder as the pullback is too much for the stock line. No need to buy aftermarket lines to use these, at least on my bike.I haven't experienced any kind of loss of control considering this setup with the bars being far removed of the triple tree like this. The bars also rotate up or down inside these clamps.Note - there is a particular pattern to the installation, with mostly tightening the lower mounting bolts on the original mount where these rises connect to, which will end up underneath these when rotated forward towards the rider. Once these are rotated, tighten the upper mounting bolts that secure them. Then add the handlebars.
Lincoln
Reviewed in the United States on July 8, 2021
So despite being the right size and in all appearances a workable solution, they cannot hold the handlebars steady. I tried to look at returning them, but of course they are no longer in the original packaging and have been installed so the instructions for return say they cannot be returned.
P. Lee
Reviewed in the United States on June 30, 2021
1st pros, these are nice and easy to install, made a big improvement for me on my Pan America.2nd cons, i do wish they went all the through it oem clamps, missed by 1/8" on both side and the clamps on the bars are also short, compared to oem clamps.Installed them and torque down, went on 165 mile ride on and off road, these are really good for me and rechecked them still right on. Hope they make a set that fits the same as oem clamps.Good luck, hope they work for you!
Recommended Products
$89.99
$ 35 .99 $35.99