Your cart is empty.
Your cart is empty.Designed to be used with Rugged Ridge of factory seat risers, these heavy-duty sliders allow the seat to slide forward and back. Each seat slider is sold separately.
Bobby
Reviewed in the United States on June 1, 2024
First off installation to the seat was easy UNTIL one of the slider bearings decides to fall out and fall apart . Once I fought with it for an hour or more I took the seat outside to install as I www to lightening the but down on the stud (yea I was using a torque wrench) the stud snapped before I could even get the nut snug. Immediately took it apart and sent in a return.
Abraham Archer
Reviewed in the United States on February 15, 2024
Exactly as described
Gilbert
Reviewed in the United States on April 8, 2024
The product is poorly made, ball bearings fall out very easy. Nearly impossible to put back in. It’s also stated to torque the bolts attaching to the riser to 22 ft/lbs. but be careful bc you might snap it like I did. 22ft/lbs is not very much and surprised that something important like a seat attachment could not withstand.
Customer
Reviewed in the United States on December 24, 2023
What a poorly designed piece of junk. The rails and sliders are heavy and well built. HOWEVER, The A frame looking bar. that is used to open the locking mechanism so that it adjusts and slides... well the ends of the A Frame that go through the mechanisms on each slide and then attach to the pivot points so that you can pull op on the A Frame and move the seat forward and back, WELL THEY DO NOT GO THROUGH. The ends on the A frame and the holes on the slider mechanism are different, the A Frame ends ARE TOO LARGE to fit through the holes. So they have to be ground down, which destroys the coating and I am sure will void any warranty. DO YOU IDIOTS CHECK HOW THINGS FIT BEFORE YOU SELL THEM? Made in china so not likely.
David Hunt
Reviewed in the United States on December 19, 2023
WORKS GREAT !!!
Rollie Lund
Reviewed in the United States on June 3, 2022
Works great
Hunter
Reviewed in the United States on March 3, 2021
Track fit perfect on a existing 1985 Cj7 bucket seat frame
Sonny
Reviewed in Canada on August 16, 2020
Ordered 2 of these. Within first month rollers and balls started falling out of slides and makes it very difficult to slide them now.
Tyler R
Reviewed in Canada on April 13, 2018
Looks like good quality. Did not fit my 92 Wrangler seat, rails were too short to bolt up.
Grant Waterman
Reviewed in the United States on August 13, 2013
My 89 YJ had a broken passenger seat slider. The handle was missing and the track on the original had split and was being held on with a machine screw (this is a bad thing for the passenger's safety). I also replaced the entire seat itself with a set of new ones I had ordered then stored 5 years ago. THe slider assembly fit on directly (followed instructions - they made sense and actually were pretty easy to follow.) I replaced the machine screw with an actual bolt from the spare/extra parts bin in my shop and they bolted down great. Slides great (it had been so long , I had forgotten that the passenger seat was adjustable!!) It's nice to have the functionality back. Thanks for a product that gave me no surprises , one that 'Just Works"
Recommended Products
