Your cart is empty.
Your cart is empty.JTEX Scroll Saw Blades Holder Clamps for Pinless Adapter Conversion Fit for Wen, Dremel, Harbor Freight Scroll Saw
Johnny
Reviewed in the United States on September 13, 2024
Nice backups.
robert
Reviewed in the United States on June 12, 2024
Great product
hunter w.
Reviewed in the United States on February 27, 2024
Fits perfectly
trademark
Reviewed in the United States on December 25, 2024
I returned this item. It came without instruction.I will say the return process was easy !!
Lonnie
Reviewed in the United States on November 12, 2024
Excellent quality fit. My scroll saw perfectly. No complaints would recommend
Wink
Reviewed in the United States on January 13, 2024
Can't use my scroll saw without these. Old ones froze up. I am going to grind these down so that I can more easily get them on the lower arm of my Rikon scroll saw. Don't know if the old ones that came with the saw were easier but these are a pain to get on the lower arm. Very tight fit on this saw not the clamp's fault.
Yosemite Sam
Reviewed in the United States on March 10, 2023
Ordered this conversion kit for my Ryobi scroll saw. It did NOT fit!
Wayne J
Reviewed in the United States on December 9, 2022
Worked perfectly. I point out that there are set screws on both sides, unlike the original, which has a slotted screw on one side and a set screw on the other. This is to help center the blade in the hole. However, it is no big issue, simply centering it by eye.
Recommended Products
