Your cart is empty.
Your cart is empty.Use the ScubaPro "300 bar" DIN to convert your first stage from a Yoke valve to a DIN valve. This is a necessary piece of equipment for divers who want to switch between regular pressure (3000psi) to high pressure (over 3300psi) tanks. Also, scuba divers who travel overseas and to the Caribbean will want to have a DIN to Yoke adapter in order to adapt to the tanks available at the local dive sites.
Donald Bailey
Reviewed in the United States on May 27, 2024
The threaded neck does not go down in far enough to seat the rubber O-ring against the regulator inside. I still gave it a five because it’s a great product
Tom
Reviewed in the United States on February 11, 2024
This one is half or less the cost of others and works well - recommend it to anyone needing to convert to DIN
Leonardo
Reviewed in the United States on July 10, 2023
The container was open and broken, also missing O-rings!!!! Let you know letter about quality!
Paul Esche
Reviewed in the United States on June 8, 2022
This part arrived quickly and works perfectly with my Scubapro MK25. I had my local shop; Sea Level do the switch for me while performing regular maintenance.
J. Taber
Reviewed in the United States on May 15, 2022
I purchased a used Scuba pro Mk17, Din, first stage.Every time I attached it to a tank it would blow the O ring from the first stage. Sometimes it would hold for a while 5 min to 30 minutes then blow. I inspected the first stage and noticed the Din threads did not look very long. I then compared it to another reg. and noticed the connector was longer.The first stage had a 200 bar connector and my tank valves were 300 bar, so the threads were too short.I bought this adapter and solved the problem.I have no clue if it came that way from the manufacturer since I bought it used.
Mark Lewis
Reviewed in the United States on August 10, 2020
I've been diving a yoke regulator with DIN tanks with DIN plugs in them for years. The DIN tank plugs always have o-ring blowouts, are the wrong depth, or don't seat right, etc.I was elated to be told that this was an option! Have this installed by a scuba shop, odds are they will charge $0-15 to do it, as it only takes them 5 minutes. It takes a torque wrench, a special narrow wall socket, and some gumption to do it yourself.
dclangst
Reviewed in the United States on October 2, 2020
I installed this on a Mk 20. As long as you can get the yoke nut off of the reg it's an easy install. An allen wrench and some vice grips. If you do a lot of these you can get a special socket that removes yoke nuts from scubatools.com.
Russell Lagore
Reviewed in the United States on September 10, 2017
I wanted to swap from a yoke to DIN on my ScubaPro MK10. It fits the MK10 first stage perfectly! Great price for the conversion kit. No directions for installation, but the procedure is fairly straight forward (of course, you should probably take it to a qualified technician). Comes with an extra o-ring not needed for the installation. Probably an extra retaining o-ring.
Recommended Products
