Your cart is empty.
Your cart is empty. Description:
Operating voltage: DC 12-15V.
Output waveform: square wave, triangular wave, sine wave.
Distortion: less than 1% sine wave distortion.
Duty ratio: less than 50ppm / ℃.
Triangular wave: with 0.1% high linearity.
Working temperature: 0 ~ 70 ℃.
Product Size: 53.8 x 37.7 x 15mm /2.4 x 1.2 x 0.59"(L*W*H).
Net weight: 18g/0.04lb.
Package Included:
1 x ICL8038 Signal Generator Module
1 x 11.8" male-FeMale Dupont Cables 3 PIN
1 x 11.8" Female-Female Dupont Cables 3 PIN
Marshall Mullins
Reviewed in the United States on March 2, 2023
It worked for a little over a week. I was using it to send signals on a project I was testing. It worked fine after I was finished. Went to compare the signal from this device against another. It wouldn't put out any signal. It turns on but no output. So I started checking the components and found a open resistor.
Love Bug 123
Reviewed in the United States on November 17, 2023
After reading the reviews I thought that this unit was from heaven. It does have excellent stability in output voltage. It generates clean sine wave. But, the temperature-frequency drift is absolutely unacceptable for my application. Frequency drift due to ambient temperature changes makes the unit unacceptable to me. I'm sending all 5-piecies that I bought back.
Lowell Vanhook
Reviewed in the United States on September 12, 2022
nice low cost generator
Mimie
Reviewed in the United States on December 10, 2022
Works well, modulation slightly shaky, but once it’s set it’s ok
systemguy
Reviewed in the United States on January 26, 2020
I tried all the modes over the frequency range and they work as advertised. The circuit requires well-filtered and regulated power for correct operation. I tried to use a 12 V charger for a power bank and had significant ripple problems. I switched to the battery power bank (which simulates a well-filtered power supply) and did not have any problems. I was running the output without a load except for a 10 MegOhm scope input. In that situation, the AC coupled input required almost a minute to settle to a balanced output. I suspect that a 100 K or lower load would get rid of this effect. Good product. One thing that should be pointed out is that this is essentially a demo board for the IC, rather than a direct replacement for a commercial function generator. Changing frequencies, waveforms, duty cycles, and correcting waveform distortion involves changing jumpers and adjusting 5 trimpots. You can definitely generate all the waveforms with this small board, just not quickly and effortlessly.
Recommended Products
