Shopping Cart

Your cart is empty.

Your cart is empty.

Sommerfeld Tools 1-1/8 inch Opening Offset Collet Wrench Compatible with Most Porter Cable Router collets. Change bits from Above The Router Table!

4.6 (4) Write Review
Free shipping on orders over $29.99

$19.98

$ 7 .99 $7.99

In Stock

About this item

  • Sommerfeld tools bent wrench allows you to change bits in seconds from above the Router table top; no need to raise or lower the router.
  • Made to fit 1-1/8” collet nuts
  • Reach under the table and hit the spindle lock with one hand, turn the wrench to loosen the collet nut
  • We also have other wrench sizes 13/16, 15/16. and 7/8
  • Make sure you measure your Collet nut first before you order!


Marc’s bent wrench allows you to change bits in seconds from above the Router table top; no need to raise or lower the router motor


Tony
Reviewed in the United States on March 19, 2025
Wrench is not deep enough for my router. It slips off of the nut.
Kempstien
Reviewed in the United States on September 11, 2024
Finger saver. Offset head works well in under table mounted router.
T. Mckinney
Reviewed in the United States on February 15, 2024
The (1-1/8") size was correct for my various Porter Cable routers, so this will work. However I was rather disappointed at the scratches and RUST on the surface. The general fit-and-finish are not worth the $20 for EACH wrench.
McDouglas
Reviewed in the United States on November 19, 2024
with my big PC router set up in my Kreg table, the original (straight) collet tool would not reach the lower large nut on the router shaft. This offset wrench is needed to clear the edge of the router table. works well. only need one.