Your cart is empty.
Your cart is empty.Standard Motor Products AX163 Air Charge Temperature Sensor
Luis M.
Reviewed in the United States on July 2, 2024
Entregas a su tiempo
daugherty
Reviewed in the United States on June 12, 2023
Worked perfect!
Customer
Reviewed in the United States on April 8, 2023
This is not a simple replacement part but was well worth the time and effort to replace it. The ECM recognizes this part and A/C unit is working as new.
Troy Stanley
Reviewed in the United States on July 29, 2022
Was really a pain in the you know what to install.Ford should be ashamed of themselves.My son now has AC again in hottest time of the season.Product worked well.
Hunter Biden's laptop
Reviewed in the United States on April 18, 2021
My 2012 Fusion was showing evap temp at 36°F when the ambient temp was 80°+. I decided to try this one instead of Ford to save a few bucks and also because the failed unit was a Ford replacement. It took about 1.5hrs to replace and was showing accurate temp I would say within a degree or two. My air now blows around 40° at idle with ambient temp around 75°. I know people said this failed, but I have had good luck with the brand in the past. I honestly think it's just a poor design and any will fail after time. I would save $10 or so and go with this over Ford.
C.G.
Reviewed in the United States on August 3, 2020
Exactly what I needed for 2009 Fors Fusion a/c problems.
DC
Reviewed in the United States on October 14, 2020
Worked great for 2 months, then quit. As you probably know, these are not easy to replace. Most of the dash has to come out to get to it. It worked fine for 2 months and now is reading 338 degrees for evap temp, like its shorted to ground. Just out of the return period, so looks like Ill be going to ford for a new one.
Kelly Mitchell
Reviewed in the United States on July 23, 2019
If you are looking for this part, you know that it is a 4 hour + job to pull the dash and replace this inexpensive part.However!With a little research, I found how to wire this baby under the dash where the original part connects by the blower motor. 30 minutes. Works great! Most instructions include buying the right sized resistor. I used this part instead.I’m sure there are many excellent reasons to not do this. But. It works. I saved a fortune.
Recommended Products
