Your cart is empty.
Your cart is empty.Standard Motor Products S820 Pigtail/Socket
GCPhotographers
Reviewed in the United States on May 31, 2023
great quality product and did the job.
Erica Hayes
Reviewed in the United States on March 14, 2023
Was good for the money and it did perfect
ROMO
Reviewed in the United States on November 9, 2023
Needed to replace the connector to the Idle Air Control Motor/Actuator, as the plastic housing was "cooked" after that many years under the hood and the latch was no longer holding the connector in place.Well made and exact fit. Thank you.
cody brannon
Reviewed in the United States on May 4, 2022
This did not fit This was not correct connector that I needed
Andy.Dandy
Reviewed in the United States on May 23, 2021
High quality item but the plug did not fit where I needed the repair, the engine temperature sensor. Good part and easy to return when I could not use.
Mor
Reviewed in the United States on December 4, 2021
fits temp sensor socket for wj 2004 wj grand cherokee 4.7lbut its a struggle to weld it to the orginal harness wires.. should have made the wires a bit thinner.. i hope the weld holds up
dionisiocasil
Reviewed in the United States on October 9, 2021
this pig tail do not match to the linepigtail line is in the center side to sideand in the bottom also in the center butin the solenoid the line is off center also the bottom is off line need to removed line tosnug in the pigtail and lock.
Johnny Blaze
Reviewed in the United States on July 26, 2019
Didn't want to pay 47$ for an OEM pigtail for my Chrysler 300 Washer Level Sensor connection and this standard plug did exactly what I needed it to do with a little modding and trimming on the sensor, I no longer have to stare at that stupid yellow "low washer fluid" light on my dash! Thank you again for the product and speedy shipping! If you need a 2 prong pigtail, this is it! A+!
Recommended Products
