Your cart is empty.
Your cart is empty.From the Manufacturer
Use Morse Taper tooling on your R-8 machine with the help of this sleeve. Outside taper: R-8. Inside taper: MT no.2.
Chaz
Reviewed in the United States on March 9, 2021
Good concentricity and run-out (0.0015" TIR for adapter & MT2 center vs. 0.0005" TIR inside spindle). However, although the MT2 bore is clean, there were a few burrs on the face of the adapter that I cleaned up to prevent possibly dinging the MT2 tooling (1 star deduct).Also, you will need a length of 5/16" Brass rod to knock out any mini lathe MT2 tooling (shorter shank than standard MT2 so a drift won't touch the back of the shank).
Tommy R. Jones
Reviewed in the United States on January 30, 2020
Exactly what I needed to use one of several tools I acquired recently from an estate..
TJH
Reviewed in the United States on September 13, 2019
Well made, used it on my wood lathe. It worked perfectly.
DEEPNHOCK
Reviewed in the United States on May 24, 2017
Worked great!
Bill K.
Reviewed in the United States on April 13, 2017
I almost didn't buy this product based on a review. I'm glad that I decided to take a chance. The product I received was of the highest quality and standards. I would certainly recommend it to people who need this product.
acad-man
Reviewed in the United States on March 13, 2015
good quality
Jerry M.
Reviewed in the United States on October 4, 2015
Near "0" runout. Performed as expected. Completely satisfied.
sasgw
Reviewed in the United States on January 24, 2015
As best I can determine, the runout is negligible. I don't see any with a 0.001" indicator. It's well finished and hardened.One detail was a problem (for my use, at least). The M2 arbor I want to use with it is threaded for a 3/8-16 drawbar. (It's the arbor on an ER collet chuck). I expected to be able to slide the required 3/8-16 drawbar down through the 7/16-24 threaded hole in the adapter to reach the M2 arbor. Surprise! There isn't a 3/8" diameter clear hole through the adapter. The center section is constricted to hold a tang-style M2 taper. I was able to drill through,with difficulty, with a 3/8" diameter carbide masonry bit. The distance is only about 3/4", or less, but as mentioned the arbor is hardened and the drilling was pretty noisy. It worked, however ,and it's now possible to put a 3/8-16 drawbar down through the arbor. I won't take off any stars for that, however, and I can't think of any other reason to de-rate it.
Recommended Products
