Shopping Cart

Your cart is empty.

Your cart is empty.

Superbat CB Coax Cable 2ft UHF Pl259 Male to Male Right Angle RG58 Coax Cable PL-259 Jumper for HAM CB Radio, Antenna Analyzer, Tunner, Dummy Load, SWR Meter 2-Pack

Free shipping on orders over $29.99

$14.99

$ 6 .99 $6.99

In Stock

About this item

  • CB antenna cable right Angle Low Loss UHF Male PL-259 to UHF Male PL-259 Coax Jumper Cable (2pcs)
  • CB Coax Cable length: 2ft(60cm) | Cable type: Flexiable Quality Waterproof RG58 Coaxial Cable | Impedance: 50 Ohm
  • PL 259 coax connectors: Soldered PL-259 connector elbow to PL259 right connector, Great For CB, Amateur Ham Radio & 2 Way Radio Hookups
  • These 50ohm coax cable Used for Antennas, Antenna Analyzer, dummy load, Radio Scanner, Ham Radio Transceiver, SWR meter, CB Radio, Handheld Radio, Amateur Radio Equipment. for FireStik Heavy SO-239 Mount Antenna, SO-239 Stud Mount etc.
  • The PL259 cable right Angle can be adapted to a wide range of installation environments, maintaining good signal transmission quality while bending the cable. It also prevents excessive stress on the cable at the bend, which effectively extends the life of the cable.



Product Description

01

Superbat CB Coax Cable, CB Antenna Cable, RG58 Coaxial Cable UHF Male to Male, 50 Ohm for HAM Radio Antenna

Product parameters

  • Type: Coaxial cable, Male UHF elbow PL-259 to Male UHF elbow Pl259
  • Impedance: 50 Ohm
  • RF Cable Type: RG58
  • Cable Length: 12Inch / 2 Feet / 3 Feet
  • Connector Type:
  • Connector A: UHF Plug Right angle, Male pin/pl259
  • Connector B: UHF Plug Right angle, Male pin/pl259
3

Used for Antennas, Antenna Analyzer, Radio Scanner, Ham Radio Transceiver, SWR METER,CB Radio Handheld & Amateur Radio Equipment.

  • Prevent damage to your radio's UHF antenna connection due to having to change antennas for base, mobile, or to a different style than stock antenna use. Adapter will take all the wear and tear; instead of the chassis connector being subjected to wear or coming loose. You can now quickly and safely change the more popular and wider selection of available UHF antennas, and help to protect your radio from damage, all at a low cost.
  • Adapter allows you to:

  1. Quickly change antennas to base, mobile or different style use.
  2. Use the more popular and wider selection available of UHF antennas.
  3. Prevent chassis connector wear or from coming loose due to antenna changes.

Greg - CDA
Reviewed in the United States on July 1, 2024
I purchased both 2- and 3-foot jumpers and appreciated that they had right angle connectors. The problem is that they were "Swivel" connectors. I really wanted to like them. Initially they worked great, but I was still apprehensive about the swivel connection.Over time the cables lost connectivity resulting in an "Open" condition on several occasions. The issue, besides loss of received signal, is that if used with a transmitter they can often result in burning out the final amplifier transistors so the unit will never transmit again (until repaired by a shop).I first noticed the issue when either my base station shortwave radio or scanner would not pick up any signals. I would touch or move the cable slightly at the swivel point whereas the radios worked again. Could be an oxidation/electrolysis issue at the internal swivel connection, which occurs over time.I imagine the issue could be much use in a mobile environment.Replaced with standard jumper cables and used dedicated right-angle adapters where needed.
don s
Reviewed in the United States on August 14, 2023
I previously bought the 1" length of these to use on a as needed basis for an SWR meter. It served the purpose and at the time, I didn't pay much attention to the "swiveling" nature of the connections. I recently bought a pair of 2" ones to connect two CB radios to an antenna switch. This is when I noticed the unreliable connection of them. With radio on, I noticed that as I tried to move the cable a little, the signal cuts in and out as the connector "swivels". If one were to be transmitting at the time the connection gets iffy, you would be risking blowing out your radio. I won't be trusting any of them any more. Not worth the hassle and cost to return so I guess I'll just eat the loss of what I spent to get them. If you value your radio, I would not use these! Update: I mentioned 1" length. I meant 1 foot.
John Miller
Reviewed in the United States on November 6, 2023
Works great for connecting a radio to a nearby tuner or antenna switch. I really like using right angle connectors so I can push gear farther against the wall if needed. I measured both with a NanoVNA first and found that both were properly connected and had very low loss, as expected for RG-58.
Brian
Reviewed in the United States on November 30, 2023
a 2 pack is perfect for my new radio. I like the angle becasue I can move the radio closer to the wall. without stressing the cable. I would like to find some shorter cables in the future. maybe 6"
SHERRY STOUCHKO
Reviewed in the United States on January 6, 2023
GREAT DEAL !! THANK YOU!!
M. Downs
Reviewed in the United States on June 13, 2021
These were truly terrible. Wide open connections at every turn. It's a VERY tiny solder joint under the cap that simply breaks at the slightest pressure. I had two sets and they were all equally bad.
Grizzly Bear
Reviewed in the United States on June 25, 2020
Seems well made and nice 2ft right angle allows cable to tuck in tight on rear of radio.
Joyce H.
Reviewed in the United States on February 12, 2020
Perfect interconnect cable!
Recommended Products