Your cart is empty.
Your cart is empty.infohawk
Reviewed in the United States on March 7, 2025
I bought this unit a few years ago for a plastic injection molding machine. Unit has been rock solid for years of continuous use and it works well to this day.
Jon
Reviewed in the United States on March 5, 2025
Junk, don’t waste your money. Didn’t work out of the box. Again, JUNK!
Simon
Reviewed in the United States on December 24, 2024
This controller works great for the price. It came pre programmedThe temp control is very simple.
Home Brew
Reviewed in Canada on January 11, 2022
First off, I will say that my experience started off a little rough. The unit was not assembled properly (one of the SSR terminals was in the wrong spot and after some head scratching I figured it out) Would have returned it but I was leaving for a few months and wanted to see it working.Once I got it hooked up, very easy to do IF the terminals are in the right spot, I was amazed at how well it worked. I use my oven to powder coat and cure composite parts, and it was very hard to control in the past. After one cycle, this controller was able to reach and maintain the exact temp and only over shot by 1ºC. I was blown away.The kit I got came with the controller, a thermocouple and the appropriate SSR (solid state relay) I have terrible luck with odd issues and would give this 5 out of 5 IF it would have came with the terminals in the right spot.
Toyota guy
Reviewed in the United States on July 14, 2021
Its a well known product with fast delivery.
Ed
Reviewed in the United States on July 14, 2021
Work as should for my application, haven't used much at this time
Chris Brown
Reviewed in Canada on January 3, 2021
Awesome for the price!
Jared Dwyer
Reviewed in the United States on March 6, 2020
It just arrived. Was fulfilled by Amazon.The irony in all of this. It was scheduled to show up after the 9th.I've been extensively prepping. Had just received the final parts I needed yesterday to build a UV-C Sterilization Unit.Planned on getting started on it today after a nap.RIP Me.
Jason H.
Reviewed in the United States on March 16, 2020
It was missing the probe,And unclear instructions
Dan
Reviewed in Canada on April 4, 2020
Nice little controller, figured out how to change from celsius to fahrenheit, looking good, I needed it to control 2 oven elements to build a powder coating oven. First attempt to load both on the same SSR melted the SSR and the controller (see picture). Bottom line it will not support more than 20A even if mounted on heat sink and if you can, use a fan to keep it cool. I build a second unit, bullet proof! Each element connected to one SSR to split the load, used heat sinks and a fan, everything ordered through Amazon. It runs fine and cool. I included pictures and the wiring diagram used. I have been using it now for 8 months. I had to replace the power switch also because the first one melted as well, I order the grey one that has a metal case on Amazon, much better quality for few extra bucks but you will buy only one which is cheaper (see picture). You can buy electric wires that support up to 600 degres F. The temperature measurement is off a little bit but I use a second thermometer so I can compensate. Take your time and build it safe !
Recommended Products
