Your cart is empty.
Your cart is empty. Automatically activates the fan, keeping your engine in its optimum temperature range.
Electronic temperature replacement part sensor.
Improved reliability over mechanical switching solutions.
Programmable set-point fan switch.
Installs without cutting of fluid lines.
Kits include 4in. SPAL fan, TTV temperature meter, radiator bracket, temperature replacement part sensor and wire harness.
JimWatl
Reviewed in the United States on May 22, 2024
the product conforms and meets my needs.
Joey
Reviewed in the United States on March 10, 2023
Awesome product, worked great on my 2023 CRF450x. This is a must for any bike!
Ronald Swogger
Reviewed in the United States on November 26, 2023
This works as it should, doesn't kill power or anything, setup was super easy, and you couldn't ask for much more. ALTHOUGH I WISH THE CONTROL UNIT CABLE WAS LONGER. I ended up installing thr controller in my fairing because the cabling was so short.
Chavdar Chavdarov
Reviewed in the United Arab Emirates on October 21, 2023
Highly recommended item, especially when it comes to MX desert riding. Easy and quick to install.
Roadracer
Reviewed in Canada on April 10, 2022
Le ventilateur lui meme est de marque SPAL donc de qualiter...MAIS...LE filage reliant la batterie a l ensemble apposer au radiateur est de beaucoup trop court..pour n importe quelle moto.doit souder un filage supplementaire pour rejoindre la batterie...tandis que le fillage allouer pour le TTO et le mettre au guidon mettons est de loin trop long..le monde a l envers.ridicule au possible comme situation..de plus faut mentionner que le service technique trail tech est INEXISTANT.ils ne repondent pas au telephone..aucun retour de message..ils ne repondent meme pas sur leur facebook...parlons d une culture d entreprise des plus merdique possible..et oh j oubliais..ne vous attendez pas a des instructions detailler incluses dans le package..ont dirait qu ils on penser a faire des econnomies en faisant attention aux depenses d encre sur le papier. Vraiment moronique comme attitude d entreprise.
Carlos Daniel Dorta
Reviewed in the United States on July 4, 2021
It doesnt work with WR250 2008
Eric Mcdaniel
Reviewed in the United States on May 7, 2021
I installed the fan on my 2017 RMZ450 to prevent overboiling, with few modifications on the bike I was able to fit the fan on the left radiator. There is a power and ground wire on the right side of the bike that doesn’t run anything I was able to tie into to run the fan. Stock stator runs the fan just fine.
JULIO
Reviewed in the United States on February 3, 2021
This is a great fan kit, easy to install if you have any mechanical and electrical knowledge. After the install, it kept my KX250 XC dirt bike at 180-190 degrees when idling and having a temp gauge let you see the temp drop while riding.
Recommended Products
