Shopping Cart

Your cart is empty.

Your cart is empty.

TUFFIOM Outboard Boat Motor Stand, Outboard Engine Stand w/Wheels, Boat Motor Support Storage Carrier Cart Dolly 440lbs Capacity for Motor Repair Maintenance

Free shipping on orders over $29.99

$52.99

$ 26 .99 $26.99

In Stock

About this item

  • 【DURABLE STEEL CONSTRUCTION】- The boat motor cart with tubes made of steel.It is wearable and have a long service life. It can holds up to 440 lbs. And the hanging board is made of solid wood, which is stronger and can fix the outboard motor.
  • 【EASY TO MOVE】- Designed with a swivel front wheel and 2 large rear wheels. It makes moving it around easier and enhance the stability. It's suitable for all kinds of road environments and more easier for you to transport the engine.
  • 【ERGONOMIC HANDLE】-Designed with ergonomic handle allows you to steer and move the cart more conveniently.It can reduce the pressure on your arms and your wrists.You can move it around the garage at ease.
  • 【MULTI-USE】-The boat motor cart is ideal for the storing, maintaining and transporting the outboard engine in the garage. It can help you hold the outboard engine for repair or maintenance.
  • 【EASY ASSEMBLY】- Designed with simple structure and equipped with a detail mannual,the outboard engine stand can be assembled in a breeze.(TIP: It would be better if you do not fully tighten the screws until all the parts are lined up properly.)



Product Description

1
1

FEATRUES

8" SOLID WHEELS

8" SOLID WHEELS

Ergonomic Handle

Ergonomic Handle

Solid Wood Hanging Board

Solid Wood Hanging Board

1

Solid Steel Construction

1

Swivel Front Wheel

1

Convenient to Install

1

Tammi Paulson
Reviewed in the United States on September 29, 2024
Not easy to assemble but eventually got it done. Attractive & held the motor as stated
Adam M
Reviewed in the United States on August 9, 2024
This is not rated for 440lbs. The caster bent with my 140lb motor. This ultimately led to my brand new motor coming to a crash on the ground, damaging the motor and prop. This was on my flat cement driveway. DO NOT BUY THIS.
Pops
Reviewed in the United States on August 6, 2024
Just what the doctor ordered to hold my small outboard motor
Possum king
Reviewed in the United States on August 4, 2024
The holes are out of spec, and the wooden board you are supposed to mount your motor on must have been cut and packaged when it was wet because it was shrunk and did not line up with holes to bolt it on. While this pretty straightforward to assemble the instructions are garbage and don’t help much at all. You’ll get some blurry pictures that don’t show you the step to take very well and there are no words as well. If I could go back in time I’d spend the extra $20 to get a better stand.
Darrel
Reviewed in the United States on July 12, 2024
This stand was easy to put together. It rolls easy and is very sturdy. Mounting the engine was a breeze. The lower part didn't stick out too far to trip over setting the engine in place.
Mark K.
Reviewed in the United States on December 9, 2024
I especially liked this model because of the front wheel. Works well with my 5hp.
angiedew
Reviewed in the United States on January 21, 2024
Short Shaft only.The instructions are a step above worthless since they show where most parts go.Very light duty, but works for my 5hp motor. Wouldn't trust it for anything bigger than that or heavier than 50 pounds.
Andrew Madro
Reviewed in the United States on September 16, 2023
Would work on a short shaft motor. I have a long shaft 9.9. It not tall enough to hold it good.
Recommended Products