Your cart is empty.
Your cart is empty.Victor TurboTorch 0386-0105 A-14 Tip Swirl, Air Acetylene can be used with any Air Acetylene torch handle (PLF-A5 or G-4). Add range to your torch kit with economical tips that also feature a removable orifice screw. The industrial applications are high capacity and HVAC. The tip size is 1/2 inch and gas flow is 14.5 at 14 PSI SCFH and 1.23 at (0.9 BAR) M3/HR. The soft solder is 2 to 3-1/2 inches and the silver braze is 1 to 2 inches.
Carlos reyes
Reviewed in the United States on May 4, 2024
Muy buen producto está funcionando correctamente
Diyplumber
Reviewed in the United States on January 28, 2024
I have an A-3 & A-5 tips. This A-11, made the 1 1/2" L copper much easier to sweat.
C. Turner
Reviewed in Canada on May 8, 2023
It's a large turbo torch tip. It's great for brazing copper lines. Just be aware it burns a lot of acetylene.
Nathan Martinez
Reviewed in the United States on March 17, 2023
Works great for 3 and 4 inch copper.
GAL Power
Reviewed in Canada on March 13, 2023
As advertised.
scott
Reviewed in the United States on September 5, 2021
Works great
Pentti Makela
Reviewed in Canada on February 2, 2021
Works well with large 2 1/2" pipe size
Rodney GB
Reviewed in the United States on April 20, 2021
The A-11 torch tip I received worked flawlessly for 3/8, 3/4 copper hvacr soft copper pipe brazing w silPhos 15%. Ambient temperature outside was ~ 55°F and breezy. No doubt it would have done 7/8 or 1” no problem. The tip is much louder than my a-3. Noticeable whistle effect. Impressive to say the least. Gets the copper dull cherry red quick.
D J
Reviewed in Canada on September 19, 2019
Heats up 2inch easy
Jim peterson
Reviewed in the United States on June 22, 2019
Good tip works with no problem
John P LaFond
Reviewed in the United States on December 8, 2019
It’s the older style tip, but works just fine. It arrived when they said it would,too.
John H
Reviewed in the United States on August 2, 2016
Turbo torch tips are the best; expensive but will last a life-time. Even as removable/replaceable jets. If you're a pro and sweat a lot of copper, this is the setup to use. American made.....I like it.
Recommended Products
