Your cart is empty.
Your cart is empty.Will fit most brands of hand guards that require handlebar inserts. For both aluminum and steel bars. Sold in pairs.
johbra1973
Reviewed in the United States on September 28, 2024
If you bought hand guards that arrived with cheap bar-end inserts that just don’t hold or strip out, these will fix you up! These are high quality and made with high grade steel bolts that will allow you to crank them down tight without stripping. Great product- I have them on 2 of my dirt bikes. Soapy water will help them slide into place during install.
mj
Reviewed in the United States on December 17, 2024
These will work for a number of handlebar ends, for your hand guards. They are great!
Nick Bashlor
Reviewed in the United States on January 7, 2024
Exactly the part i needed after rolling my Quad and bending stock handlebars. i replaced them with aftermarket twin wall aluminum and my stock handguard bar inserts would not fit. I needed a smaller diameter insert to lock my full wrap handguard ends in place.
Tomek
Reviewed in the United States on April 24, 2024
These are so much better and more substantial than what came with my handguards. One fall and the original was loose and could not be made tighter. These are not only far longer with way more bite, the plastic sleeve offers a tiny bit of give, so should withstand impacts better.
Public Name
Reviewed in the United States on June 16, 2023
Went through 2 poorly designed sets before. these the only ones that fit tight in the handle bars on my wife’s Honda 100F which has the OEM 7/8 hands bars. Ordering a second set to swap out on my 450R.
Laura213
Reviewed in the United States on November 21, 2023
Lost the bolt out of my cycra probend, replaced with these and work great. They fit into the countersunk holes of the hand guards well. No idea the longevity but I needed them asap and got them within 2 days. The cycra hardware is a liiiitle nicer but I think the rubber insert will be holding on much better.
Yanmarguy
Reviewed in the United States on October 14, 2023
Grandson bent handlebars needing to take everything off and reinstall on new bars. In the process one of the clamps from the Tusk guards was damaged. Finding these saved the day! The exact replacement for the originals!!!
Brandon
Reviewed in the United States on April 16, 2022
My wife's Ryker has handle bar with about 18mm inside diameter. The lower (part that inserts furthest) end expands just fine to fit, but had to wrap black tape at the outer end to ensure no wobble. Worked great - YMMV. Good quality and great product for the price.
Recommended Products
