Your cart is empty.
Your cart is empty. This windshield mount is a good choice for people who want to bring their handheld radios to use in the car. Unlike regular phone/tablet mounts, it supports walkie-talkies to be used with a belt clip.
Easy to install and you can adjust it for the best use. Easy to mount your HT without a lot of effort.
Be able to quickly remove/take out and put back your GMRS/Ham handheld radio.
Can support up to 1.22" wide handheld radio’s belt clip. Suitable for Motorola, Talkabout, Yaesu, Midland, Baofeng HT and scanner with a belt clip.
A radio mount is also an essential accessory to provide a safe and convenient communication environment in the car.
Glock 26
Reviewed in the United States on September 29, 2024
I like this mount. The suction cup is strong, and stays in place. (I moisten the surface of the suction cup so it has better staying power).The adjustments also stay in place when tightened. There are enough adjustments to enable you to position the radio where you want it.I tried this on my Retevis, Baofeng, and Motorola XPR 7550 HT's, (I own all three), and the belt clips fit nicely. The Motorola belt clip is a little snug when sliding it in or out of the mount, but not bad. There are probably other brands of radio and scanner radios that will work with this mount.My personal preference is to attach this to the driver side window rather than the windshield, because it is easier to reach, and view the radio screen, but that will vary depending on the vehicle.
SMH
Reviewed in the United States on August 22, 2024
The mount keeps moving even if you tighten it
Gia
Reviewed in the United Arab Emirates on November 20, 2024
Was initially skeptical of the quality as it is entirely plastic and low cost. However it has now done an entire season holding radios without any sings of wear. Definitely would buy again for the price.
Adam Wampler
Reviewed in the United States on October 2, 2024
It's a little difficult to get everything tightened up as much as I'd like, but it's pretty good in comparison to some other window mounts I've had. It's adjustable enough to come up with a proper up/down, left/right, and rotational angle, but getting the plastic stop nut tight in conjunction with the belt-clip bracket can be a challenge. If you've got a clean window and you make sure the suction cup is clean as well, then this seems to have pretty solid grip on the glass.I haven't really experienced it, but obviously a heavier object would be more likely to cause the pivots to move round or pull the suction cup off the glass. It works fine for smaller radios like a Retevis or smaller Baofeng, and a heavier Radioddity has been fine so far as well. I suppose really hot weather, sunshine, or really cold weather could affect the suction though.I'm pretty happy with it so far. I keep one in my truck, and I'll likely get another one for my office at some point.
Recommended Products
