Shopping Cart

Your cart is empty.

Your cart is empty.

Twidec/2M with Plug Stainless Steel K-Type Sensor Probes Metal HeadProbe for Thermocouple Sensor & Meter Temperature Controller(Temperature Range:0~600°C) MT-6340-C 4x30MM

Free shipping on orders over $29.99

$9.99

$ 4 .99 $4.99

In Stock
  • Type: K Type; Measuring Range: 0~600℃
  • Probe Size: 4mmx30mm; Terminal: Plug
  • USA Thermocouple Sensor and Wire, Glass Braid Insulation
  • 2 Meters long cable;Probe Material: Stainless Steel
  • Package Include:1 x Temperature Sensor Probe


This product is just a replacement accessory of your device. We suggest the instruction of your device to know how to connect. If the item you have received is defective or get some other issue in any way, please fell free message us for help or free replacement or refund without return.


Rémy B.
Reviewed in the United States on September 18, 2024
Good quality,. Only time. Will tell how long they will last
EUROTUBOS INDUSTRIAL
Reviewed in the United States on May 9, 2024
ESTE ARTICULO LLEGO DESTAPADO PEDI 4 Y LLEGARON 3 ARTICULO
Shoxter
Reviewed in the United States on May 6, 2024
I constantly have to keep my eye on this thermocouple while it connected to my Fieldpiece manifold. This probe is compatible with field pieces hardware but not quite made to properly fit the S3’s manifold port…
Georgia Peach
Reviewed in the United States on January 5, 2023
I purchased this to check oven temp at 350 deg. Within 1deg accuracy of 2 other digital thermometers. Would purchase again. Not a lot of money and works quite well. If you treat it right it will last.
Buyer
Reviewed in the United States on April 26, 2023
Compared to another probe, this one reads a few degrees low. Fairly certain the other one is correct. But was close enough to work.
Andrew g.
Reviewed in the United States on October 13, 2022
Works perfect. Exactly what I needed for at work
Dimitar Pandoursky
Reviewed in the United States on August 23, 2020
ok!
Barry S.
Reviewed in the United States on March 7, 2020
Well, they read about -3F from actual 32F, but overall not bad. The end tip does not appear to be sealed, so not recommended you submerge them in liquid. I did remove the connector clamshell to verify the wires were tight in the screws, they needed a smidge of tightening. The connector fits my General Tools meter just fine. Overall not bad, but definitely not precision stuff. FYI, the connectors are not std mini connectors, so beware. As example, they will not fit into the frame of a Fieldpiece ST4.
Recommended Products

$24.50

$ 11 .99 $11.99

4.7
Select Option