Your cart is empty.
Your cart is empty.Perfect for your Visor Bar or Dash Light, the 18 Inch Ultra Bright Lightz Large Gasket will shield your eyes from dangerous flashback while driving at night with your LED warning lights are on. Easily fits onto almost every brand of light and can easily be cut to fit your particular light or windshield perfectly. What's Included: (1) 18" Large Rubber Gasket Tech Specs: 18.5 inches long Measurements: .65” X 2” Can be easily cut to size with tin snips Perfect for reducing flashback Extruded rubber can be trimmed to fit your window’s curve Universal fit for most brands of lights.
End User
Reviewed in the United States on August 29, 2024
Have visor lights inside my POV, and the flash back made it very had to impossible to use lights at night. Installed the this on my visor lights, now have to look to see if lights are on. Highly recommend if you have a flash back issue.
George DeBord
Reviewed in the United States on November 3, 2024
Works like its supposed to.
Kris Montano
Reviewed in the United States on January 28, 2024
Easy to cut to length, easy to install, and prevents a lot of flashback due to visor lights not being flush with the windshield. Has adjustable clip area, so if it does not fit tight on your visor lights just squeeze it together and put it back on the visor lights.
jon smart
Reviewed in the United States on April 18, 2024
Easy to trim and easy to fit. Keeps back flash off you at night.
Jonathan Furmage
Reviewed in the United States on July 20, 2023
I feel like it depends on the gap of your visor light and windshield, but this would work great for me if I had 1 more inch of this material, it does cut out a lot of back flash!
chris
Reviewed in the United States on October 31, 2023
Worth the money used on visor lights keeps flashback light off dash. Looks great and very sturdy not cheap. Easy to install.
A.B.
Reviewed in the United States on October 29, 2023
The material is flimsy and would sag. It didn't even touch the windshield, so it only reduced flash back about 30%. Returned and used a piece of black corrugated plastic and it worked much better!
RM
Reviewed in the United States on June 20, 2021
One works fine. The other is sagging on one side for some reason. First, I'm sure these would be easier to install on a metal housing light bar, mines a plastic STL housing, so a little more difficult. I had to take the light bar out of the mount, not a difficult task, so no big deal. They are about 19 to 19 1/2 inches long, so using Raptor shears I was able to trim with no problem. I used a flat head scre driver to get dish soap into the groove, and bent about every 3 or 4 inches. Once I got it on, I bent the rubber over and squeezed by hand until it was seated all the way into the groove. Little more squeezing until It was all on nice and tight, reinstalled light bar to bracket. My light bar is a permanent mount, so you cannot pull it all the way out, was still fairly easy. So far have held up in Texas heat with no problem, and reduced the flash back a LOT. 4 stars because the one is sagging, and they are only a week old. Even with the one sagging, not going to go through the hassle of a return, little strip of gorilla tape and it will be fine. Does.notnprevent side flash, but I fixed that with a small piece of black plastic and tape. Looks good, works. Only one comes in a package.
Recommended Products
