Your cart is empty.
Your cart is empty.Product Description
Ultra-Small GPIO Terminal Block Breakout Board Module for Arduino Mega-2560
Product Description：
- The item has been soldered and assembled. Support for Arduino Mega-2560.
- Terminal block pitch 2.54mm/0.1", wire size range 28AWG to 18AWG, strip length 4.5mm, screw M1.6 steel, pin header and cage copper.
- FR-4 fiber glass PCB, dual copper layers.
- Pin header connect to Arduino board. The breakout board is firmly fixed to Arduino-Uno through standoffs and nut, and will not shake.
- Packing list: 3x(1 set, A B C each one) terminal block breakout modules, 6x 11mm nylon standoffs. 6x 6mm nylon standoffs. 6x nylon nuts, 1x small slotted screwdriver (NOTE: the item not include Arduino Mega-2560 module).
Name
Reviewed in the United States on January 5, 2025
Good product, fits up well with the mega but the nuts are nearly impossible to fasten on. It would be cool if there was a tool to help with fastening them to the bolts.
Herman L. Ulloa
Reviewed in the United States on July 3, 2024
Since parts are small, a little difficult to screw in the supports but, very stable once installed. The terminals worked perfectly and the pins fit snugly without tightening too much. Well labeled. I recommend securing wires before connecting to the Mega board if you’re just transferring. I Highly Recommend.
RealHuman
Reviewed in the United States on October 7, 2024
Works as advertised
David Goodsell
Reviewed in the United States on May 28, 2023
Installs nicely. Wires connect at edges so important LEDs on board are not blocked. A good jewelers screwdriver is easier to use than the provided screwdriver. The nylon standoffs are fairly delicate so a light touch is needed. Extra standoffs are provided in case of problems.
Edward Carter
Reviewed in the United States on October 19, 2023
Usable but sloppy workmanship. I bought two sets. Some minor bowing evident in one set and more serious bowing of one of the longer pc/terminal strip boards in the other. Connections appear to be okay but it is not ideal especially at the high price they are charging for the kit. Nylon standoffs are terrible! It is best to assemble the longer standoffs loosely to the strips before pushing the strips into the headers on the controller card because threading the tiny nylon nuts onto the standoff is nothing short of a nightmare. Fortunately, they include some extra standoff pieces which you may need if you are not really careful with this nylon trash. Assembly documentation not strictly required but at the price they are charging a simple picture of the finished assembly would be nice.
Johnny Dirks
Reviewed in the United States on September 27, 2022
I like the idea but it would be nice to have some screws to attach the Arduino to something.Sometimes it would be nice to be able to add shields. This arrangement does not allow that.
consumer
Reviewed in the United States on March 27, 2022
Well made, good form factor, a real timesaver. Easily install, relocate wiring as required. A bit pricey, but anymore what isn't.
Marty
Reviewed in the United States on November 1, 2022
If you have a project where your Mega is wired up in use on a somewhat permanent basis these connectors fit the bill. Nicely made, fit well, hardware is OK. Not a Phoenix, but not the Phoenix price.
Recommended Products
$34.99
$ 16 .99 $16.99