Your cart is empty.
Your cart is empty. Universal controller, works with either mechanical relay or SSR
Display: One lines, Four digits. ºF or ºC
Input type: TC: K, E, S, R, J, T, B, WRe3-WRe25. RTD: Pt100, Cu50
Input range: K (-200~+1300ºC), S (-50~+1600ºC), WRe3-WRe25 (0~2300ºC ), R (-50~+1600ºC), T (-200~400ºC), E (-200~900ºC), J (-200~1200ºC), B (350~1800ºC), Pt100 (-99.9~600.0ºC) or (-200~+600ºC), Cu50 (-50~150ºC)
Display Resolution: 1°C, 1°F, or 0.1°C, 0. 1°F with Pt100
Accuracy:±0.2% or ±1 unit of full input range
Control mode: PID, On-Off
Output mode: Relay contact: 3A at 240 VAC. SSR: 8VDC, 40 mA
Alarm: Process high/low alarm
Power consumption: Power supply voltage rating: 85~260VAC/50~60Hz or 85-360 VDC
Dimension 24 x 48 x 75 mm (1"x2"x3")
Chance Evans
Reviewed in the United States on April 5, 2024
I replaced my device with this, be careful and be sure then pin numbers match when replacing. Check the bottom screws for pins and not the side.My current ones casing was on backwards and the one I ordered was correct. I Ended up connecting 120v to the new ones SSR pins and blew them. Had to order a 2nd.Instructions are great and link is to a google document, perfectly safe and even if you have no experience. Easy to understand.
Jennie C.
Reviewed in the United States on November 1, 2023
Come with no instructions. Only a web address to get them. The web page is blocked by security software as a hackers page!!
Jake Munsell
Reviewed in the United States on April 8, 2022
Easy to program and configure for custom build casting furnaces. I use K-type thermostat and kanthal wire.
Recommended Products
