Your cart is empty.
Your cart is empty.Attaches to the crank arm. The magnet can be used as a cadence magnet for most brands of cycle computers.
Sam N Renkin
Reviewed in the United States on September 11, 2024
The included adhesive tape does not work well, but the small size is perfect for a narrow gap between crank and chainstay. Comes with a zip tie, or use a dot of outdoor rated double sided foam tape.
Hendell
Reviewed in the United States on December 7, 2024
Para mi bicicleta
Dana C. Constance
Reviewed in the United States on January 7, 2024
Clever design
Easy and anywhere
Reviewed in Saudi Arabia on November 19, 2023
Good strenght
Paul Cowell
Reviewed in the United States on September 21, 2021
Sticky part on back is not sticky, used 2 sided tape to secure it for cable tying.
Aaron Magnuson
Reviewed in the United States on August 4, 2020
Easy to put on, works like it supposed to.
Ramón D
Reviewed in Spain on March 2, 2020
Cumple con su función, lo utilizo para mi garmin recomendable por su calidad precio
TheMeinsta
Reviewed in Spain on November 10, 2020
Añadido a un sensor de cadencia Garmin sin ningún problema. Se me perdió el imán original y éste ha funcionado perfectamente.
Mark12
Reviewed in the United States on October 26, 2019
Yes, it’s just a magnet but I’ve had them that weren’t strong enough to trip the switch (or whatever). This one works fine!
Expo
Reviewed in Spain on June 15, 2017
Lo utilizo con un teasi y perfecto. Económico y cumple con lo que quería. No es más que un imán al fin y al cabo.
Big G!
Reviewed in the United Kingdom on November 30, 2017
Works fine
William Ross
Reviewed in the United States on September 28, 2016
I wish this is what I would have received with the original computer purchase. I went through too many of those rubber ones before installing this. Simple and effective
Josh (Xaminmo) Davis
Reviewed in the United States on October 26, 2013
Ugly zip strip, and it doesn't stay put. You could add some foam tape to hold the zip-strip in place.If your pedal axle is steel (magnets stick to it), then you can buy a 10-pack of 1/2" by 1/4" magnets to stick on your pedal axle. Much better.If your pedal uses a wrench instead of a hex key, then a 1/2 by 1/8 will also work, and will be slightly more accurate, but you'll never dig it out of the hole until the pedal is removed.If you're stuck with aluminum, brass, or titanium pedal axles, then you may want to put a blob of clear "Shoe Goo" on this before strapping it down, and let that cure for a day. That will keep it in place better.
Recommended Products
