Your cart is empty.
Your cart is empty.Product Description
5304502763 Replacement Stove Knob for Frigidaire Range / Stove / Oven
Product information :
Item 5304502763 Stove Knobs compatible with Frigidaire Gas Range Stove/Oven
Material: Polybutylece Terephthalate（PBT）
Dimensions: 2.0 inches(Length)*2.0 inches(Width) * 1.78 inches(Hight)
Packing: 5 x 5304502763 Stove Knob for Frigidaire
Advatage :
TURNEGOO stove knob is made of high quality Polybutylece Terephthalate（PBT）.
High-resistance Polybutylece Terephthalate（PBT）plastic with the advantage of corrosion resistance, high temperature resistance and strong reinforcement. So that it can be installed more secure, durable sturdy and prolong the lifetime.
Save a lot of money for you. You can own such great replacement knobs at half the cost of original OEM ones.
[Replaces Part Number: ]
5304502763 range stove knobs, only replace part numbers: PS11724147 AP5984069 EAP11724147 4279473
Compatible with Following MODELS but are not limited to:
5304502763 control knobs are only compatible with brand Frigidaire. Work with these application models: DGGF3046RFA, DGGF3046RFB, DGGF3046RFC, FGGF3045RFA, FGGF3035RFB, FGGF3035RFC, FGGF3035RFA, FGGF3045RFB, FGGF3045RFC, FGGF3035RFD, FGGF3045RFD, etc.
If you are not sure if our product is suitable for your stove or not, please do not buy it yet, Typical questions asked about products，let our technical engineer tell you whether it can be purchased. Thanks.
Choose the correct model
The installation hole diameter (D shaft size) is 0.25 inch/ 6.23 mm in length, 0.22 in/5.63 mm in width, (please refer to size picture) and measure your burner insert size to make sure this knob fits before purchasing.
Easy to stall
Easy to install the part YOURSELF and quickly get your range oven burner back to work within few minutes.
Multiple protection to prolong the lifetime
Made of high-resistance Polybutylece Terephthalate（PBT）plastic with the advantage of corrosion resistance, So that it can be installed more secure, durable sturdy and prolong the lifetime.
Installation Steps
Step 1
Pull the old knobs directly from the connection stem.
Step 2
PLEASE NOTE!!!
Please clean the oil and rust on the connection stem. If they are not cleaned, it may cause a mismatch between the knobs and the stove.
Step 3
Please pay attention to the direction of "D", then press our TURNEGOO knobs straight down onto the connection stem.
Thomas U.
Reviewed in the United States on March 9, 2025
fits my stove no issues yet
K. Hanna
Reviewed in the United States on March 16, 2025
They did what I needed but they are not stainless steel, just plastic coated with a silver topcoat.
tjj
Reviewed in Canada on July 17, 2024
Fit was excellent. Seems sturdier than the original knob
Jim Peterson
Reviewed in the United States on November 28, 2024
These knobs are really junky. They worked fine for a few weeks, then began failing by not staying on properly (sort of sliding inward) and then stripping out. They are winding up in the trash, one by one. Junky quality, avoid.
Glenn Mullins
Reviewed in the United States on January 26, 2024
I didn't use the knobs as they did not match my stove but that was expected. I have a Kenmore Elite Range model 79078303011 where the small metal clip in the center of the (metal) knob cracked. The knob would no longer turn on the burner and fall off. I looked all over to try to purchase they clip and it appears it's not sold separately. I purchased these knobs because they were designed for a frigidaire and the shaft size for the gas burner was exactly the same size and I was hoping that the metal clip would be the same. Once I received the new knobs I pulled out the center metal clip and installed it in my Kenmore knob, worked perfectly. I now have 4 more clips for future use.
DLee
Reviewed in the United States on September 26, 2023
Some purchasers reported that the knobs melt. They probably melted because they were too close to the stove. The original knobs have a stop inside to keep space between the stove and the knob, these do not have that. When you initially put them on they are flush to the stove, too close! So I used a toothpick to stuff mine with little pieces of paper towel until they stopped at the right place. That way, when you push in the knob to turn on the flame there should be at least a 1/8 of an inch gap between the stove and the knob and when you release the push there should be almost a 1/4 of an inch gap between the stove and the knob. If you have not discarded your original knobs use that to measure. Since receiving the knobs I've baked several times at 425 degrees and my knobs have not melted. As a matter of fact, they look great! Originally, I purchased my stove in 2015 and just recently the silver coating started peeling off of the knobs so we know the knobs were not designed to last forever, but the replacements really do look great and in turn makes the stove look newer and so much better. I'm so happy with this purchase! I hope this works for you! Have a great day!
Kevin McKnight
Reviewed in the United States on March 19, 2023
They fit my model: FFGF3056TSA, which was not listed here. The Frigidaire website also provided confusing information on the correct part. So, I measured twice and ordered these under the plan that they could be returned. But, voila, they fit. And look nice! The latter of which isn't a miracle considering the state of the originals.Word of caution: these are still plastic. But, at least they are ~$40 for a set instead of the $40 a piece that Frigidaire wants to charge (for plastic!). Shame on them.ETA...it took a few months, but the knob on the front high burner has started to peel and warp.
Robert Syverson
Reviewed in the United States on April 22, 2023
These fit perfectly on my Frigidaire stove. Am exact match. Yes, they are cheap plastic coated with silver paint that can flake off over time, and are expensive for what you get, but they are far cheaper than ordering directly from Frigidaire. Very pleased.
DL
Reviewed in the United States on December 14, 2022
1. They didn’t fit a Frigidaire as they misstated they did2. Very cheap plastic. I can’t believe they are safe to be on a hot stove3. Don’t waste your money
Recommended Products