Shopping Cart

Your cart is empty.

Your cart is empty.

Upgrades Aluminum Center Slider Driveshaft for 1/10 Arrma SENTON Granite Big Rock VORTEKS Outcast 1/8 Typhon Vendetta RC Car Upgrade Parts (Red)

4.6 (7) Write Review
Free shipping on orders over $29.99

$19.88

$ 9 .99 $9.99

In Stock
  • Compatible With:The Center Slider Driveshaft Set for 1/10 Arrma SENTON GRANITE BIG ROCK VORTEKS OUTCAST 1/8 TYPHON VENDETTA,Replaces AR310884.
  • High Quality Metal: Made of high-quality aluminum alloy material, Increased crash resistance and long-lasting durability during the most extreme RC action, Solve the problem of drive shaft fracture.
  • Easy to Upgrade: Upgrade replace Arrma AR310884, Can directly replace the original center slider driveshaft. (Pay attention to check whether the drive shaft set model of the vehicle manual is AR310884, To avoid the returns products and save your time due to the inconsistent model).
  • Great Performance: CNC High quality moulding for precision fit, Spring-steel spring for consistent performance.
  • What You Get: 1 x Front Section Center Slider Driveshaft, 1 x Rear Section Center Slider Driveshaft, 1 x Spring.



MDF
Reviewed in the United States on August 13, 2024
This is a long mile off from fitting, I am very disappointed. This is not good for Amazon at all. Advertising a item to fit and being for a completely different scale model. Buyer's watch out.
PM
Reviewed in the United States on June 22, 2024
I bought this piece for my typhon 3s and it ran good for about a day till it broken in half mid run.
Damion
Reviewed in the United States on February 17, 2024
This does not fit the Arrma Vorteks.
tdick bk
Reviewed in the United States on December 9, 2023
First drive test .metal dust it's soft metal an chew up my mini gear
Jeremy Sasser
Reviewed in the United States on December 15, 2023
This driveshaft has a smaller diameter than the stock plastic one so keep in mind the bearing will not fit - it doesn't need the bearing though and is much better than plastic
oTTo
Reviewed in the United States on November 28, 2023
I got this for an infraction mega build that I converted to 3s brushless. So far it holds up good. I did need to get 2 rubber O rings to hold the center bearing in place but no big issue. I think this will stand up to the 3s power just fine much more and the shaft would wobble a bit causing strain on other parts.
MrE
Reviewed in the United States on November 13, 2023
A strong driveshaft -- can cause other issues due to extra weight and now that it's less flexible (can really bend them with big launches and no other chassis reinforcement)