Your cart is empty.
Your cart is empty.Product Description
U.S. Solid 3/4" 110V AC Normally Open Solenoid Valve, VITON gasket, Solid Brass
The U.S. Solid electric solenoid valve features a durable brass body, suitable for outdoor but not underwater use. It's favored by customers for DIY projects, moderate temperature and chemical applications, as well as for controlling flow in irrigation, reverse osmosis, and motorcycle systems.
Direction of the Flow
Most U.S. Solid Valves are UNIDIRECTIONAL
Make a note of the arrow on your valve. Most U.S. Solid valves are unidirectional. This means they are intended to flow in one direction only, in the direction of the arrow. If connected in opposite directions, the valve will not actuate properly (will not close for Normally Closed valves). Additionally, be sure the medium passing through is filtered. If not, particles will cling to the gasket over time, which can cause it to not seal properly.
THREADING
U.S. Solid Valves follow National Standards for pipe thread. We suggest the use of Teflon tape to ensure the seal of the NPT threading. The tapered male and female thread form angled surfaces that with increased torque squeeze the Teflon tape resulting in a tight seal.
OVERHEATING
These valves should be energized for less than 8 hours. While most do not have more than 18W of power, the coils are in a contained area and can burn out if energized for too long. We suggest a computer fan to keep the coil cool if necessary to energize continuously for extended periods.
POLARITY
- For valves with 2 wires, the valve will actuate regardless of which terminal each wire is connected to (+ or -). Some units include a ground wire. Open up the connector and look for the ground symbol (as shown in the corner).
- For valves with a ground wire, please be sure to ground the valve.
GASOLINE and PRESSURE WARNING
- NBR gaskets should not be used with gasoline, kerosene, or other petroleum products. If your valve requires contact with these substances, opt for one with a VITON gasket.
- All solenoid valves need some pressure to actuate. This is especially true of pilot or indirectly operated valves.
Ryan Peters
Reviewed in the United States on April 27, 2024
purhased 2 months ago, i installed it, verified functionality. then it didnt get used for the 2 months but water was passing through it. went and tested it today and its not working. its too expensive not to work
Edwin R Garcia Diaz
Reviewed in the United States on August 27, 2023
Muy buen producto funciona exelente
modesto cardenas
Reviewed in the United States on July 25, 2022
Good construction
Jorge
Reviewed in Mexico on December 28, 2022
Pese a que el producto fue golpeado durante la importación, no le afecto en su funcionamiento.
Recommended Products