Your cart is empty.
Your cart is empty. Product Description:
Size: 28 x 48 x 8.5 mm
Supports GPS+GLONASS (default); GPS+Beidou;
GLONASS+ BeiDou multiple modes Built-in LNA signal amplifier
Built-in Flash, free configuration product baud rate,
output statement, output rate, second pulse and other parameters
Built-in TCXO Crystal and Farad Capacitors for Faster Hot Start
1-10Hz update rate
Frequency: L1, 1575.42MHz
Baud rate: 4800,9600,19200,38400,57600,112500bps
Channel: 56
Sensitivity
Tracking: -164dBm Capture: -159dBm Cold Start -147dBm
Cold start: average 26 seconds
Warm start: Average 24 seconds
Hot start: average 1 second
Timepulse signal: RMS 30 ns
The maximum height: 50000 meters
Speed: 500 m/s
Acceleration: ≦4G
Update frequency: 1-10 Hz
Operating Temperature: -40°C to 85°C
Storage temperature: -40°C to 85°C
Package Includes:
1 X USB GPS Module
david1024
Reviewed in the United States on May 3, 2024
this shows up, out of the box, as /dev/ttyACM0 (thats a zero, not an O) on most Linuxes. And the accuracy is pretty bad with the internal antenna. however, it improves greatly with an external antenna. I'm not sure how it reconciles the difference between internal and external antenna locations, but I'm using it for time, not location. The silkscreen on the board is a bit misleading in that it has TXD/RXD when that's actually USB D+/D-. I removed the connector and had to do a double-take when I soldered on what needed to use and rechecked that it was USB an not rs232. I suppose there may be a mode for the chip where it can do either that is set at the factory.... lsusb shows it up nicely and you can watch in minicom with 115200/N81 if you like too. The PPS has a 10% duty cycle that matches the green LED flashing. once I get this project done, I may update this with position and timing jitter information.
Rick
Reviewed in the United States on April 20, 2024
this is absolute GARBAGE. Dont purchase this.. I let it sit outside for almost 12 hours with a clear view of the sky and it will not get a fix on a single satellite.
M.
Reviewed in the United States on August 21, 2023
Using on my Pi and have had 0 issues getting it working and keeping it working. It has an LED that blinks green when its got a satellite lock that is very useful. Be aware - It's a little wider than standard USB devices and it partially covers the USB port next to it, making that port unusable. Simple solution is a 3" USB extender or a 90 degree right angle extender.
Don Marlin
Reviewed in Canada on December 9, 2022
This thing was maybe accurate to +/- 10 meters after sitting for a day.Pretty disappointing. Not recommending anyone buy this.
ur_a_buS
Reviewed in Canada on November 25, 2022
Shielding wasn't properly soldered onto board and fell off. Poor manufacturing quality.
Mike
Reviewed in the United States on August 23, 2020
This increased my accuracy of my Stratux box.
Daniel S Ratcliffe
Reviewed in the United States on July 11, 2020
Works with raspberry pi using gpsd software.Has external antenna connector for gps
Customer
Reviewed in the United States on July 11, 2020
This items works very well and even has a connection attached to the circuit board where you can attach an external gps antenna.
Stephanie
Reviewed in the United States on March 12, 2020
Works well in my stratux device, decent accuracy 12m. Would buy again for other applications.
jfromok
Reviewed in the United States on March 12, 2020
Works perfectly. Plug and play for stratux build.
Demonsthenes
Reviewed in Canada on November 26, 2020
As long as it works, which it does, it's good. Just try to keep it away from heat and EM noise sources!
Recommended Products
