Your cart is empty.
Your cart is empty.Product Description
Mark Rios
Reviewed in the United States on January 6, 2023
These work great. They are small so check you dimension needs.
Justin
Reviewed in the United States on August 31, 2022
I used them for creating an Arduino open platform RC transmitter and they work great, low profile and easy to fit in a project. Plus if you have a 3D printed you can even find little stylish knobs to print that will snap on top of the slider.
Arthur Sliter
Reviewed in the United States on November 17, 2022
Works well but came covered in a thin layer of grease and very little instruction could be found. The pins are not properly spaced for a bread board but if you push hard enough they’ll bend into place.
disfrazao
Reviewed in the United States on August 11, 2021
Some reviews seem to be for different products; at the time of writing this listing is a 5 pack of 100K Ohm linear slide pots. Of the 5 received, actual resistance measures at 98K, 107K, 108K, 108K, and 112K Ohms and the taper is linear as described. The blade shaft is black and made of rigid plastic and the mounting holes require M2-.4 screws.
Steve Streza
Reviewed in the United States on July 24, 2021
Did not fit a breadboard without forcing pins to bend. Pots are not linear, they're logarithmic. They have a dead zone at the end of the track, and even at stable, there is a ton of noise in the signal. A complete waste of money.
Pb
Reviewed in the United States on July 17, 2021
Product works well
Adrian Mccarthy
Reviewed in the United States on August 26, 2020
The pins have the standard size and spacing to work on solderless breadboards. A quick check with a multimeter indicates they provide the advertised range, from less than 5 ohms at the low end up to just past 10K at the high end--better tolerance than a lot of regular resistors. The slide action has a nice smooth feel. One of the ones in my pack had some lubricant all over it, but it wiped up easily and works just as well as the others. For a finished project, you might want to find or fabricate some caps for the slider, but they're fine as-is for prototypes and experiments.
Recommended Products