Shopping Cart

Your cart is empty.

Your cart is empty.

uxcell 8mm to 8mm Bore Rigid Coupling Set Screw L25XD14 Aluminum Alloy,Shaft Coupler Connector,Motor Accessories,Blue w Wrench

Free shipping on orders over $29.99

$6.34

$ 2 .99 $2.99

In Stock

About this item

  • Connection Bore Diameter: 8mm to 8mm; Total Size:25x14mm/0.98''x0.55''(LxD);Thread Diameter: 3mm/0.12".
  • Widely used in blowers,3D printer,DIY robots,CNC machine,stepper motors,etc. Similar to rigid clamp couplings, shaft couplers are used to hold bearings and sprockets tightly on the shaft, and are used in motor and gearbox assemblies.
  • Top tight type rigid coupling with 2/4 screws to hold the shaft tightly; high torque with rigidity, low inertia and excellent sensitivity.
  • NOTE: The rigid type basically does not allow eccentricity, and it must be fully adjusted during use.
  • Single piece set screw clamp design makes it easy to set up the items on the shaft and control the holding capacity of the coupling.


-The coupling is great for connect your motor of 8mm to 8mm shaft to the wheel. -Can be used in electric car toy, robot, etc.


Johnny Mountain
Reviewed in Canada on March 20, 2025
Exactly as described in the ad, good quality, and it works well. The hex screws seem small but so far they have held up well, and do the job. So far - 5/5
Rob
Reviewed in the United States on August 14, 2024
Use as coupling for a fiberglass rod on my boat. Fit and worked great.
Dr.T.
Reviewed in the United States on January 7, 2020
These might be ok for a 3d printer but are junk on a cnc that actually puts some torq on the lead screw.
Customer
Reviewed in Canada on June 26, 2019
Merci
Sharon
Reviewed in the United States on June 25, 2019
It is what it is, but it is frustrating the set screws come loose after a few hours of turning. Fixed it with a bit of locktite, but shouldn't have to.
Mario's nestoros
Reviewed in the United States on January 12, 2019
It will be used on my remote control boat I'm building with a jet drive
KC
Reviewed in the United States on July 16, 2018
Can not tight up enough, it will alway lose again. I think the side thread clamp 90 degree better than 180 degree angle to hold on tight.
Wilberto García
Reviewed in the United States on December 1, 2018
Perfect
Darren D.
Reviewed in the United States on April 23, 2018
Good product.
Laura in Louisiana
Reviewed in the United States on December 2, 2017
just what i needed
Recommended Products

$13.99

$ 6 .99 $6.99

4.6
Select Option