Enjoy free shipping on orders over $29.99

US Dollar

0 $0.00

Your cart is empty.

uxcell K-28 V Belt Machine Transmission Rubber, Black Replacement Drive Belt 28 inch Pitch Girth 8mm Width 6mm Height JIS Standard

4.9 (10) Write Review

Free shipping on orders over $29.99

$7.29

$ 3 .99 $3.99

In Stock

Qty.:

About this item

Size: Model: K-28; Pitch Girth: 28 inch; Top Width: 8mm; Thickness: 6mm; Angle: 40 degree. Produced according to the Japanese standard JIS K 6323, the length will be less than the same specification of the American-Standard RMA_IP20
Material: It is made of neoprene rubber for resistance to oils, water, and some solvents.
Function: To link two or more rotating shafts to transmit power in a drive system. Even load distribution on belt drives and good wear resistance.
Feature: The trapezoidal shape of the belts cross section wedges into the groove of a similarly shaped sheave or pulley to provide traction and alignment.
Applications: Used for drive systems in the automotive, agricultural, textile, printing, mining, and office equipment industries, ect.

Product Description

How to measure the length of the required belt:

Wrap the rope around the two pulleys
Make a mark
Place the marked rope on a flat surface and use a tape measure to measure the distance between the two marks, which is the inner circumference of the belt

To accurately measure the length of the v-belt, use a belt measuring tool or a soft ruler, not a steel ruler.
The width and thickness of the belt should also be measured to confirm the type of belt.

Installation:

First, loosen the tensioning device, then press the v-belt into the pulley groove by hand, and finally tighten it again.

Notice:

Pay attention to the wear of the belt groove of the v-belt pulley.
Check whether the centerline of the two pulley shafts is parallel, whether the corresponding pulley slots are aligned, and whether there is any skewing phenomenon.
When one v-belt is badly worn and cannot be used, replace all the v-belts at the same time, with the same type and equal length, so that each belt has the same tension.

Maintenance:

Regularly check the v-belt tension, after adjustment still can not meet the specified requirements, must be replaced with a new v-belt.
In use, the operating temperature of the v-belt should not exceed 140°F, do not apply belt grease casually.
Various types of v-belt, should not be coated with rosin or sticky substances, but also to prevent v-belt from oil, butter and gasoline, otherwise, it will corrode the v-belt, and shorten the service life.
V-belt should be stored at a relatively low temperature, with no direct sunlight and no oil and corrosive fumes place.

Application

Lawn Care Equipment

Repair lawn equipment, snow removal machine

General Purpose

Repair band saw, box fan, drilling machine, trimmer

Automotive Repair

Replace the automotive belt



Customer Reviews	67	232	280	109	22	18
Type	B	A	M	K	O	SPZ
Width	16mm	13mm	10mm	8mm	10mm	10mm
Thickness	11mm	9mm	6mm	6mm	6mm	9mm

clyde

Reviewed in the United States on August 14, 2024

Wasn't sure it would fit the bill. Actually, it works as good as the original.

Dana mr money

Reviewed in the United States on April 27, 2024

Drill press

T. Jennings

Reviewed in the United States on November 23, 2023

Short version see my other review on the K27. I ordered a K27 for my drill press and it was much smaller than the one I was replacing. I sent that one back and ordered this K28 which fits perfectly so I have to presume these belts run about a inch smaller than there size indicates. Quality seem to be alright the belt runs smoothly and the price is right. Docked a star due to the sizing issue.

David C.

Reviewed in Canada on October 4, 2023

The belt was longer than expected so it didn't get used.

Walter Wright

Reviewed in the United States on August 26, 2022

Thanks fits well

Denis V

Reviewed in Canada on November 19, 2022

Un peut courte mais ça fait là job 😉

Dave Appleby

Reviewed in the United States on April 2, 2022

Fast shipping and worth the money

Vanessa

Reviewed in the United States on September 8, 2021

To small for a k 28

Jamie A.

Reviewed in the United States on May 23, 2021

Exactly what I needed. Doesn’t flex or drift at all.

Customer

Reviewed in the United States on December 3, 2021

All good.

Shopping Cart