Your cart is empty.
Your cart is empty.Product Description
Reset Temperature
Normally Closed: When the temperature falls to the reset temperature, the thermostat contact can be connected again. (If the reset temperature is not reached, the thermostat contact is also disconnected)
Normally Open: When the temperature falls to the reset temperature, the thermostat contact can be disconnected again. (If the reset temperature is not reached, the thermostat contact is also connected)
Please Note :
- During installation, the temperature switch should be completely close to the mounting surface of the tested appliance.
- Do not collapse or deform the plastic / metal shell during installation.
- For metal temperature controller, when using, do not remove the insulating sleeve to avoid electric leakage.Not suitable for working in water.
- Not suitable for air temperature sensing, only applies to contact sensing.
Nathon J Hansen
Reviewed in the United States on May 6, 2024
Did not work…. finicky! Did not trigger when heated until way beyond set temp. Must be imported trash. Don’t waste your money. Gave 1 star because didn’t have negative stars.
dlusk
Reviewed in the United States on April 6, 2024
Used this for a pellet stove and it does the job well.
Steve norsworthy
Reviewed in the United States on July 27, 2023
I planned to use these to switch on a cooling fan. Even tough the temp went over 40 it didn’t switch on. I finally heated it up a lot more to switch it on but then it didn’t switch off. I threw them away a bought a small digital thermostat, which works perfectly and was only a few dollars more
jawdat A.
Reviewed in the United States on July 22, 2022
Item is like described will buy again.
jason p.
Reviewed in the United States on May 24, 2022
Temperture at 58c and no closed action. Bought the 40c actuation modelCant get either switch to activate. I only have a simple 12v circuit. Maybe it need more potential? But i doubt it, should conduct at temp regardless of potential? I will trouble shoot more.
the consumer’s consumer
Reviewed in the United States on September 27, 2021
I used these to keep my 3D printer fans off unless the printer is running. Super cheap mod to keep your work space quiet.
John Coode
Reviewed in the United States on February 6, 2021
These worked perfectly to control entertainment center cooling fans.
Recommended Products
$98.98
$ 42 .99 $42.99