Your cart is empty.
Your cart is empty.Product Description
Reset Temperature
Normally Closed: When the temperature falls to the reset temperature, the thermostat contact can be connected again. (If the reset temperature is not reached, the thermostat contact is also disconnected)
Normally Open: When the temperature falls to the reset temperature, the thermostat contact can be disconnected again. (If the reset temperature is not reached, the thermostat contact is also connected)
Please Note :
- During installation, the temperature switch should be completely close to the mounting surface of the tested appliance.
- Do not collapse or deform the plastic / metal shell during installation.
- For metal temperature controller, when using, do not remove the insulating sleeve to avoid electric leakage.Not suitable for working in water.
- Not suitable for air temperature sensing, only applies to contact sensing.
Ron
Reviewed in the United States on March 18, 2020
Works good. Added to fan of power supply for 3d printer. Not sure if it's exactly turns on at 45 but it turns on after just a few minutes of the heat bed heating and turns off after a while.
Recommended Products
$121.95
$ 51 .99 $51.99