Your cart is empty.
Your cart is empty.Product Description
Feature
The Push-to-connect end can be rotated 360 degrees even after installation, which is convenient to use and has good sealing performance.
Material
Made of plastic and brass, with high strength, good sealing performance and long service life.
Applications
Mainly used for air compression systems, vacuum systems, pneumatic systems.
Note:
1.Make sure that the cutting surface of the pipe is vertical. Please insert the tube into the bottom before use.
2.When inserting the pipe into the joint, it must be inserted into the end, otherwise there may be a leak.
3.After plugging in, try to pull the tube, if you can't pull it out, it means it has been connected.
4.When loosening the tube, first confirm that there is no pressure in the tube, and then evenly press the end cap to the bottom.
Greg's Laser
Reviewed in the United States on September 4, 2022
they work perfectly and so well I ordered a second set as back up
Customer
Reviewed in Canada on March 20, 2022
Très bien
Steve
Reviewed in the United States on January 10, 2022
I was a little suspicious right off the bat when they were very lose in my pneumatic cylinder. I decided to line them up with my machinists square and measure with my calipers. Yup these are NPT not straight cut 1/8 aka G or BSPP threads.
Recommended Products
$5.80
$ 2 .99 $2.99