Your cart is empty.
Your cart is empty.Product Description
Robert Shuler
Reviewed in the United States on January 18, 2025
You get a lot of people saying a pre-fitted bridge isn't an exact fit. Well, none are because every violin is different. You have to file it down a little and shape it to your preferences, and probably thin the upper front part a little. Having a small hand grinder is faster, but a little oops and you go to far. Make tiny grooves for the strings and put pencil graphite in them so the strings slip. Beveling the feet is usually not critical.
Mackenze
Reviewed in the United States on September 25, 2024
I’ll just be nice cheap option for a bridge on my violin. And this is how they sent it to me broken and wasn’t packaged appropriately at all no stuffing just how it is shown in picture.
Carlotta Horn
Reviewed in the United States on November 4, 2024
It fit perfectly
Jill Pfluke
Reviewed in the United States on November 2, 2024
Perfect fit. Easy to install. Good value.
Kem
Reviewed in the United States on November 2, 2024
Just what I needed for my 1/2 scale violin project for my little niece. Well made, cut well, saves labor! Thanks. Kem. Nov. 1,2024
ct_djr
Reviewed in the United States on March 10, 2023
This bridge is very well shaped and pre-fitted. Every bridge should be tweaked to match the specific violin it is fitted to, but this one needed the least amount of adjustment that I've seen. It is very close to "plug-and-ply". The dimensions of the feet and the top edge are nearly perfect already - no shaving required. The edges were nicely sanded too. I wish it were 2 or 3 millimeters taller, but that's a problem with my violin's fingerboard, not this bridge. I was happy with this purchase.
Curt Wuollet
Reviewed in the United States on August 6, 2022
To be fair, about the only thing you can say about "most violins", is that they have four strings. This is a violin bridge, but it was much too tall for my Gliga and it was taller than the 1.3" pictured. I would have had to remove material from both the feet and the top and completely reshape it to use it as a bridge. I did find a use for it though. I had a Sky bridge that I had purchased previously which was also too tall but less so.I didn't think I'd roll the dice again, so I used this bridge as a string lifter to keep pressure on the top while I reworked the Sky bridge. Got my warped, crushed (the kidney slots were nearly closed) bridge replaced so all's well that ends well. And it sounds just fine.The seller responded and offered a refund, but it's a good bridge and I'll keep it as a spare for a taller violin.
Michael Diebel
Reviewed in the United States on December 10, 2022
Did not fit my custom 1/4 size violin, so I needed to, cut, sand, and modify it for use.
Recommended Products