Your cart is empty.
Your cart is empty.Product Description
Reserved Holes
Rubber Grommet
Various Models To Choose
Built-in Mounting Stud
ParaPilot
Reviewed in the United States on February 10, 2025
A bit thin plastic but pretty decent for the price. I like that it has holes precut AND they supply blanking plugs for the unused holes. The blanks do stick out but I just turned then facing inwards as I was mounting these boxes side by side. Worked great for some WiFi Antenna mounting boxes for solar inverter.
David Threlkeld
Reviewed in the United States on August 25, 2024
Worked well for my project
Aaron and Maja
Reviewed in the United States on August 18, 2024
The plastic is about 2.5mm thick. There are a few mounting holes on the inside. They received a #6-32 screw fine, I was able to gently snug it without stripping the plastic. It would have been nice if they included measurements for the screw holes and plastic protrusions. I had trouble getting my calipers inside to measure, but then I realized the measurements could be taken from the outside, because the inner-protrusion features are identifiable from the outside.After getting these measurements, I was able to 3D print a carrier board on which to arrange and mount components before finally fastening them inside this enclosure.It took flat black spray paint like a champ. I removed the soft rubber plugs and 3D printed some hard, black plastic plugs instead.This enclosure will be fine for my purposes.
Dave Mozdzanowski
Reviewed in the United States on November 9, 2024
This closed box has rubber inlets/outlets that should prevent most weather from entering. It has a removable screw-on cover and is made of pretty sturdy plastic. Nice box for creating a junction somewhere outdoors or in a garage.
J.Alvarez
Reviewed in the United States on October 6, 2024
Ordered this waterproof junction box to protect power connections for two outdoor wifi cameras. UF cable brings power from the house to a power plug and dual port USB A charger inside this junction box. USB power cables from the wifi cameras are connected to the charger. Junction box is made of plastic, seems well made and complies with the IP65 standard for basic dust and water protection. It has rained several times over the past month and the junction box has protected the power connections well. Would recommend to protect low power connections outdoors.
Bark Twain
Reviewed in the United States on October 3, 2024
This is a well built junction box with a fine waterproof seal and 10 entry points for romex wire.vThe entry points are made of silicone to seal around the romex and maintain the waterproof, rustproof environment inside the box. This is a well thought out and finely engineered piece of equipment. I plan to install this in an unheated garage and use the roomy inside space to contain for three romex wires and a remote controller -- too much stuff for a standard junction box but it'll fir inside this one with ease.
AC
Reviewed in the United States on October 28, 2024
This box is a good item as far as internal space, mounting and weatherproofing. The quality is good. However, the size of the side plugs are incompatible with third-party US fittings that could be used for strain relief on the wiring.
Jason R
Reviewed in the United States on October 23, 2024
This was a perfect fit for an outdoor security light project that otherwise would have required some splices more exposed than I would have liked them. The box itself is well made and is absolutely water tight during the rains we've had. The hole templates are well placed and easy to work with, and the included mounting hardware was perfect for getting this affixed to a large piece of trim on the outside of the house. I'd happily use or recommend this brand again.
Recommended Products
$68.54
$ 29 .99 $29.99