Your cart is empty.
Your cart is empty.A unique, patented integral boot makes this popular sized illuminated mini Rocker Switch waterproof to IP 65. Single Pole, Single Throw, Off-On Illuminated. Contacts are rated at 16 amp 12 VDC. The illumination operates at 12 VDC. Black body and red button. 3/16 inch quick connect terminals. Panel cutout is .51 x .77 inches.
Kevin R.
Reviewed in the United States on August 28, 2024
Very pleased
Kimberly Domenech
Reviewed in the United States on January 5, 2024
Had to buy this to replace a light switch on my grill and it fits and works perfect. Good quality
steve v.
Reviewed in the United States on April 3, 2024
I have reported but I have yet to receive it. The page was open with no switch inside
Dale Patrick
Reviewed in the United States on March 7, 2023
It fit my Smittybilt winch, worked first time and is great!
Sherry Shimko
Reviewed in the United States on May 20, 2019
I used this switch for my under car lights, which had a switch already that had burned out. I cut a hole for it in the dash board and I have had it for months and I have no complaints.
Neil
Reviewed in the United States on June 16, 2018
Replaced the rocker switch on my Smittybilt X2O. The X20 has an IP68 rating, but the factory wireless switch has zero waterproofing. This switch works great and even lights up to show it's on! Fits perfect!
Ed
Reviewed in the United States on February 7, 2018
Works good. Just wish they made a larger one that matched the DPDT.
J. deckard
Reviewed in the United States on December 8, 2014
a tiny lighted water proof switch can be hard to find sometimes for my motorcycle. So if you're looking at this BUY IT! It's small well built, good quality plastic and excellent rubber gromet around the switch head. Use good quality connectors with di-electric grease for a solid connection in back. The dimensions are smaller than listed as it's measured from the switch Bezel not the Body so DO NOT CUT into your dash UNTIL you have the switch in hand! Also if you intend to mount this into an enclosure I would recommend a small bead of silicon around the bottom of the bezel for full sealing.
Recommended Products
