Your cart is empty.
Your cart is empty. Package Include:
6 * Waterproof ATC Fuse Holder
Greener
Reviewed in the United States on August 5, 2024
I installed a small amp and sub woofer set up in my TJ, I wanted a fuse at the battery terminal just incase. I used true 10AWG 100% copper wire. It would be about the largest you could go, you might get 8AWG to work. Make sure you feed the wire and pieces in the right order.
Riley S
Reviewed in the United States on August 24, 2024
As we all know; the more crimps, solder joints, and interruptions you have, the more resistance and points of failure you have. These are a fantastic solution to the double crimp in-line fuses you’d normally see everywhere else. If you have the tools, they’re simple, clean, and easy to install. They add an extra level of professionalism to any installation you do. I personally like to use them as inline fuses for accessories being tied into outfitter circuits on trucks, in light duty applications. Worth every penny!
alm
Reviewed in the United States on December 25, 2024
Perfect for what I needed
Aaron Hultin
Reviewed in the United States on December 20, 2024
I needed to replace an online fuse hold for a trailer tongue jack and this fit the bill while minimizing additional connectors. The plastic seems sturdy but like others mention I ran into the problem of one of the first crimes causing the connector to fail. I am now left with four housings but only enough connectors to load 3. I'll have to dive down the rabit hole to see if a generic connector is available for this application (affordably)
Mark Jones
Reviewed in the United States on November 29, 2024
I used these on a marine application specifally a boat and they are great. I wouldent say they are the easiest thing to do if you are nto expiencred but in my case I am and they are great super high quality and water tight. Love them defiently will be buying more of these in the future for the boat.
Was just what I needed to get back up and running.
Reviewed in the United States on November 13, 2024
When you need to add a fuse to stay safe.
Chris H
Reviewed in the United States on July 26, 2023
Waterproof fuse holders. Assembly required. I enjoyed assembling these. I know I have good connections now. The price was much better than premade ones and I know it's done right.
Guy Sicard
Reviewed in Canada on December 9, 2021
Good product, but you need to know they are a pull to lock style connector, so the wire needs to be put through the seal then the wire goes through the connector and then stripped and crimped to the pin. Once it is crimped the pin and wire are pulled back into the connector and is locked.
ButtKoWitz
Reviewed in the United States on December 17, 2020
These are cheap Chicom connectors. But for the price, they're handy to have around. The silicon(?) waterproofing seals slip around easily and I don't consider them good at all. Dust seals, at best.Tab for screw mount is easily and cleanly snapped off, which may or may not be a good thing (is a good thing for me, as I'm not screw mounting them, they're just "inline" fuses for my project).Crimp connectors aren't very good quality. A few of them have just broken off while crimping them (the crimp tabs on the connectors, seem a little brittle). My hunch is no copper, but honestly I didn't even look to see if they're tinned copper or just chineseium.Giving them four stars, for the PRICE POINT. These are cheap, quality wise, like almost everything here.
Recommended Products
