Your cart is empty.
Your cart is empty.Weld-On 705 Industrial Grade PVC Solvent Cement is specially formulated to handle a variety of rigorous industrial applications. This PVC pipe cement is designed for use with pipes and fittings with an interference fit up to a 6-inch diameter and is suitable for all classes and schedules (including Schedule 80 up to a 4-inch diameter). The industrial-grade clear PVC cement creates a deep fusion between PVC pipes and fittings, making it suitable for irrigation, DWV (drain, waste, and vent) systems, electrical conduit, pool and spa, and plumbing (including PVC foam core pipe). It can be used without primer on non-pressure systems if local codes permit. With its medium-bodied viscosity and fast relative set time, this PVC solvent cement applies smoothly and sets quickly to facilitate efficient PVC welding.
Scott
Reviewed in the United States on January 11, 2023
I was hopeful my regular pvc adhesive would seal and hold my septic/sprinkler system connection even after letting it cure for 24 hours but it did not. This however did the trick easily.
Rene D. Illa
Reviewed in the United States on September 9, 2022
jacuzzi leaking
Dan
Reviewed in the United States on February 8, 2019
This is the real stuff- it does its job well. It sets fast so move quick and you are done. The smell reminds me of that new car smell - might put a drop in the car after cleaning. It dries out over time so don't expect to keep around for years and dip into again. Don't leave it in a garage that gets down to freezing temps.
Customer
Reviewed in the United States on February 28, 2019
Drys fast so make sure your ready for it.
Customer
Reviewed in the United States on April 27, 2018
Used to 3 pieces of pvc framing together to make it look like a single piece. Worked great and no issues. Allow plenty of time to dry.
William V
Reviewed in the United States on August 24, 2017
Used it for pvc baseboard. Worked great. Says fast setting and it is but it takes a while to actually cure so I pre-assembled scarf joints and outside corners a day before installation. It can be glued as you go too but I was working on my own house so I didn't mind the wait. By pre-assembling I also kept the glue away from my new floor and most of the glue smell outside.
Jim
Reviewed in the United States on November 23, 2017
Works great. I used it to glue two pieces of 1x10 PVC house trim boards together along the 1" edge. It took a couple of days to fully cure, but it did what I wanted. Be sure to use clamps to hold it together.
Jon Karner
Reviewed in the United States on May 4, 2015
This was listed as an approved glue for doing a PVC trim glue up in the PDF of the PVC trim install guide.It works without a primer.It sets slower than glueing two pipes together.I was able to spread the glue out over a 2" * 50" area and still move the adjoining piece of material for a bit.I also nailed together all my work to get the glue time to set in place.
Recommended Products
